B-LED BL-FL01 Instructions

BL-FL01
Instructions for the Monochromatic LED Wireless Controller
(Enhanced version with wireless switch, no wiring needed, allows configuring
the "running water" effect on a single channel)
Basic Parameters:
1. Operating Voltage: 5-24V
2. Maximum Control Capacity: 3200 pixels (3200 ICs).
3. Dynamic Effects: 23 different types of effects
4. Remote Control Distance: 20 meters.
5. Battery Type: 3V - CR2032 (one battery).
This controller allows pairing multiple switches for synchronized control, with the
possibility of grouping and coding. Switches used with multiple controllers in the
same location do not interfere with each other.
Instructions for Using the Monochromatic LED Controller:
When using the controller, ensure the controller's switch is pointing downward:
1. First button: Adjusts speed or brightness. (Adjusts speed when the light
is on and brightness when the light is off).
2. Second button: Turns the light on or off.
3. Third button: Changes modes.
4. Reset function: Press and hold the "Mode" and "Speed" buttons
simultaneously while the light is on to restore factory default settings.
How to Adjust the Number of LED Points in the Controller:
With the light off, press and hold the "Mode" button (third button) for 5 seconds
to access the adjustment menu. Use the "Speed" button (first button) to
increase the points and the "Mode" button to decrease them. Holding the
buttons adjusts the points more quickly. Once configured, press the on/off
button to save and exit.
•
Default value: 80 points.
•
Maximum: 3200 points.
How to Pair and Clear Codes Between the Controller and the
Remote Control: