Response RM01 URC Manual

RM01URC Ed2_Universal Remote Control_Instructions_Art:-) 15/09/2014 13:21 Page 1
Universal Remote
Self-learning Ei larms Compatible Executive Remote Control
Part 1: Preparing the RM01URC for Programming
Press and hold the top two buttons,
P NIC and MODE simultaneously for
approximately 15 seconds until the LED
indicator begins to flash.
The RM01URC Remote Control is now
ready for Programming.
Part 2: Programming
IMPORTANT: When programming place both Remotes BACK to BACK and make
sure the battery in your original Remote is fully serviceable.
Panic
PANIC
MODE
Mode
1. Place your original Remote Control
B CK to B CK with your new
RM01URC Remote Control. Program
each button as follows.
2. First press and hold the MODE button
on the RM01URC then immediately
press and hold the MODE button on
ontrol (RM01UR )
Programming Instructions
Both Remotes must be
aligned at the top edge
Transmit
LED
Now simply repeat the above step for the
P NIC button.
Transmit LED
Indicator
Transmit
LED
PANIC
MODE
the original Ei Remote until the Green
LED indicator on the RM01URC begins
to flash rapidly indicating that the
MODE button has been successfully
programmed.
Personal
Attack
Arm/Disarm