Response SAURC Programming Instructions

SAURC Ed3_Universal Remote Control_Instructions_Art:-) 12/09/2014 22:46 Page 1
Universal Remote Control (S URC)
Part 1: Preparing the S URC for Programming
Press and hold the top two buttons, Instant
- rm and Disarm
approximately 15 seconds until the LED
indicator begins to flash.
The S URC Remote Control is now ready
for programming.

Part 2: Programming

IMPORTANT: When programming place both Remotes BACK to BACK and make
sure the battery in your original Remote is fully serviceable.
Instant-Arm
Part-Arm/
Delay-Arm*
Disarm
* Part-Arm with Control Unit systems or
Delay-Arm with Siren only systems
1. Place your original Remote Control
B CK to B CK with your new Universal
Remote Control (S URC).
2. Programme each button/function as
follows:
INST NT- RM
Simultaneously press and hold the
Instant- rm Button on both Remote
Controls until the LED indicator on the
S URC begins to flash rapidly indicating
that the Instant- rm Button has been
successfully programmed.
DIS RM
Simultaneously press and hold the
Disarm Button on both Remote Controls
until the LED indicator on the S URC
Programming Instructions
simultaneously for
Both Remotes must be
aligned at the top edge
Transmit
LED
Slide up
to operate
Personal
Attack
Transmit LED
Indicator
Transmit
LED
begins to flash rapidly indicating that the
Disarm Button has been successfully
programmed.
P RT- RM / DEL Y- RM
Simultaneously press and hold the
Part- rm / Delay- rm Button on both
Remote Controls until
indicator on the S URC begins to
flash rapidly indicating that the Part-
rm / Delay- rm Button has been
successfully programmed.
PERSON L TT CK
ctivate the Personal ttack Switch on
the original Remote Control by pushing
it up and holding whilst simultaneously
depressing the Personal ttack Button
on the S URC.
Instant-Arm
Disarm
Part-Arm/
Delay-Arm*
Personal
Attack
the LED