TIE DOWN 33007 Assembly Instructions

• Simple & Convenient Log Storage: Keep your split firewood or logs neatly stacked and off the ground, protecting them from rot and
insects. The DIY design allows for easy assembly in just minutes
• Customizable Design: Easily adjust the length and height of the rack using 2x4's (not included), making it perfect for any at-home
storage setup
• Heavy-Duty Construction: Made from tough, black, powder-coated steel for enhanced durability and rust prevention, providing
long-lasting, rugged craftsmanship for years of reliable performance
• Quick & Easy Assembly: Suitable for both beginners and experienced DIY enthusiasts. Assembly is straightforward using the included (32)
#9 wood screws (8 screws required per post). Please note that 8 pieces of 2x4 lumber are not included
• Precision Fit: Pre-drilled slots (3.625 in. x 1.625 in. x 3.625 in.) ensure a secure hold for the 2x4's, enabling a sturdy and reliable build
Firewood Rack Kit Includes:
4- Black Plastic Coat
Mounting Brackets
Fig. 1-1
Assembly Instructions:
1. Determine the Desired Width:
• Measure the required width of your firewood stack
and add 3".
• Cut two 2x4's to this length.
• Position the 2x4's within the brackets as shown in
Figures 1-2.
• Using the pre-drilled mounting holes, attach two #9
wood screws to the lower side of each bracket.
WARNING: This product can expose you to chemicals including Nickel, which is known to the
State of California to cause cancer. For more information go to: www.P65Warnings.ca.gov
Firewood Rack
Assembly Instructions
Part ID: 33007
32- #9 x 3" Wood Screws
Fig. 1-2
404-344-0000 • www.tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
Online Assembly
Instructions
Instructions #08467 (EC2060 - Rev. 12/11 /24)
sales@tiedown.com