TIE DOWN 33260 Installation

Thank you for purchasing the Tie Down Mailbox Steel Post Kit. This post is constructed of tough 14 gauge powder coated steel.
Included with the Mailbox Kit: universal mailbox mounting plate and four 3/8" carriage bolts/nuts/washers for attachment to your
mailbox. There are three basic methods of installation: concrete, lumber post, or cold environment.
Mailbox Mounting Plate Installation
• Locate the hardware bag and layout the 4 carriage bolts,
nyloc nuts, washers, and mounting plate.
• Position the mailbox post on level ground with the
mounting holes on top.
• Slide the universal mounting plate over the post. The
4 mounting tabs will be positioned on the outside of the
post tube as shown right in Fig. 1-1.
• Working one at a time, slide a 3/8" carriage bolt in
from the outside through the mounting plate/post. The
carriage bolt should mount flush against the mounting
plate as shown in Fig. 1-2.
• Slide a washer over the carriage bolt from the inside of
the top of the bracket/post as shown in Fig 1-3 below.
• Attach a 3/8" nyloc nut over the washer/bolt, lightly
tighten but not fully tightened.
• Repeat the process for the remaining three bolts.
• Once all the bolts/washers /nuts are in place and the
mounting bracket is squarely mounted, fully tighten all
four nyloc nuts as shown in Fig 1-4.
Fig. 1-3
WARNING: This product can expose you to chemicals including Nickel, which is
known to the State of California to cause cancer. For more information go to:
www.P65Warnings.ca.gov
Mailbox Post Kit
Installation
Part ID: 33260
Accommodates T1, T2, or T3
Size Rural Mailboxes
3/8"
Carriage Bolts
Fig. 1-1
Fig. 1-2
Fig. 1-4
404-344-0000 • www.tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
sales@tiedown.com
Universal Mounting Plate
Online
Installation
Instructions
Instruction 08451
EC2010; Rev. 2/5/23