Seiko 7T32 Setting Instructions

Seiko cal. 7T32 setting instructions
Note: your watch may have a different case or face than the one shown in the pictures.
All Reset
All reset is used when first setting the watch or when there is unusual or erratic operation.
A - Pull Crown 1 out to the second click.
B -Press Button A and Button B simultaneously.
C - Push Crown 1 back in to the normal position.
Zeroing the hands
After all reset the hands and calendar must be "Zeroed" to provide a starting point for setting
the watch.
A - Pull Crown 1 out to the second click.
B - * Press Button A to move the chrono minute hand to the zero position.
C - * Press Button B to move the chrono second hand to the zero position.
D - Push Crown 1 back in to the normal position.
E - After adjusting the zero positions proceed to adjusting time and calendar.
* Keep the button pressed to move the hand rapidly.
Setting the Date
A - Pull Crown 1 out to the first click.
B - Turn the crown clockwise until the date for the previous day appears.
C - Pull Crown 1 out to the second click and turn until the desired day appears.
D - Push crown 1 back in to the normal position.
Note: Do not set the date between 9:00 p.m. and 3:00 a.m. Otherwise the date may not
change properly.
1 of 3
Seiko Alarm Chrono
Cal. 7T32 - Setting Instructions
Created 05-07-2001
Refer to the instructions below for directions on how to set this watch
The important thing is that they all share the same basic movement.
http://www.geocities.com/watch_crazy/instructions/seiko7t32.htm
9/5/2005 9:57 AM