Teknik TITAN User Manual

[TITAN]
FLOODLIGHT
USER MANUAL
Teknik Lighting Solutions Pty Ltd | ABN: 44 608 397 913 | www.tekniklighting.com.au
INTRODUCTION
Thank you for selecting the [TITAN] Floodlight. Please ensure that the luminaire is installed in
accordance with the below instructions. Teknik Lighting Solutions Pty Ltd assumes no responsibility
for inappropriate use or installation of the product, including any associated damage caused.
PRECAUTIONS
1. Read the entire manual carefully before
installation and operation.
2. The Warranty Period is five (5) years. Teknik
will repair or replace the product if it fails
or becomes defective during normal use
within the prescribed warranty period.
3. Designed for industrial and commercial
use.
4. The lifetime of the product is affected when
it is used in a fully enclosed fixture.
5. Installation must be performed by a
licenced and qualified electrician.
6. Use solid copper wire of 18 AWG
(minimum) for the input terminal extension,
and 20 AWG (minimum) for the output
terminal extension.
7. Do not change or tamper with any internal
electric circuits or wiring, connectors or
cables for any reasons.
8. Do not insert foreign objects into the
product. This may result in electric shock,
malfunction or damage to the products.
DISCLAIMERS
1. This product must be installed and used as
per these instructions.
2. This product contains no serviceable
parts and no attempt should be made to
repair this product. If the product is faulty it
should be discarded.
3. This product is not suitable for installation
in hazardous and/or corrosive areas.
5/26-34 Dunning Ave, Rosebery NSW 2018
9. When in operation the luminaire
temperature may reach up to 60°C.
10. Teknik accepts no liability for any injuries or
damages resulting from the incorrect use of
the lamp or use of the lamp in combination
with inappropriate equipment.
11. Luminaire is non-dimmable.
12. For further information, please contact
Teknik Lighting Solutions or your local
distributor.
13. This product has no user serviceable parts.
If any part is damaged, disconnect from
mains and discontinue use.
14. Warning: Luminaire marked as NON-
IC according to ASNZS60598-2.2. Not
suitable for use on residential properties.
DO NOT COVER OR ABUT. Any insulation
material must be positioned at a minimum
distance of 100 mm from the fitting.
15. Do not cover the light.
16. The warranty shall exclude modifications to
the product, incorrect installation and use
outside of the intended scope.
4. Electrical installations periodically receive
transient over voltages. This product has
been designed to minimise the effect of
such voltages on connected equipment.
5. This product utilises intellectual property in
the form of registered designs, trademarks,
and/or patents. Such intellectual property
remains the property of Teknik Lighting
Solutions Pty Ltd in all cases.
6. This product has been designed to operate
in ambient temperatures -30 C to + 50
o
| 1300 313 780 | info@tekniklighting.com.au
C.
o
1