Advertisement

Homedics MT-CML Manual

Instructions for Comfort Pro Massage Table Set-Up

  • Unlatch the clasps that hold the table into it's folded position.
  • Open the table on it's side with handles facing up.
  • Open table legs all the way – they will automatically lock into place.
  • Hold table by the handles and tip into upright position by planting the tips of the lead legs into the floor, and pulling up.
    Set-Up - Step 1 - Hold table by the handles
  • Remove face cradle base and face cradle cushion from bottom of table.
  • Attach the face cradle pillow to the wooden face cradle base by matching up the Velcro pieces on each.
  • Slide the wooden face cradle base into the holes at either end of the table, until the desired position is reached.
    Set-Up - Step 2

When the table is first in the upright position – double check to be sure the table is level with the floor.

Adjusting the Leg Height

  • Start with the table fully opened – laying on it's side or upside down.
  • Unscrew the locking knobs on each leg (Figure 5), remove the leg, place the leg at the position you have chosen, and replace the locking knobs. Holes are numbered for easy match up. Do not over-tighten knobs. (Figure 6) Snug will do fine.
    Adjusting the Leg Height
  • Changes in humidity and temperature affect wood, it is a good idea to double check the tightness of the knobs occasionally.


Always adjust all 4 legs to the same height.

Instructions for Comfort Pro Massage Table Take-Down

  • Slide wooden face cradle base out of the end of the table.
  • Remove face cradle pillow from wooden face cradle base by separating the Velcro pieces from each other.
  • Attach the wooden face cradle base to the bottom of the table by matching up the Velcro on the base to the Velcro underneath the table.
  • Turn table upside down or on it's side.
  • Unlock table legs by pressing in on each leg at the joint.
    Take-Down
  • Collapse all legs in. Place face cradle pillow behind legs for storage. Fold the table in half.
  • Latch the clasps that hold the table closed.

Maintenance

  • To wash use a light soapy water solution to clean all surfaces.
  • Avoid harsh chemicals or solvent based cleaning products.
  • Do NOT use any alcohol, alcohol based, or petroleum based cleaners. Doing so may damage the upholstery material on your table.
  • If any of the cables on the bottom of the table break, stop using the table immediately.

IMPORTANT SAFEGUARDS


Please read all instructions carefully before using this product.

  • Close supervision is necessary when this table is used by, on or near children, invalids or disabled persons.
  • This unit should not be used by children without adult supervision.
  • Do not jump, stand, or walk on the table. The table is solely for the purpose of laying on to receive a massage.
  • Double check that legs are locked in the open position before using the table.
  • Make sure all four legs are adjusted to the same height and the table is level with the floor before using the table.
  • Do not leave the table unattended when a person is laying on it.
  • If any of the cables on the underside of the table breaks, stop using the table immediately.

For more information regarding our product line in the USA, please visit: www.homedics.com
HoMedics Service Center
1.800.466.3342
8:30 – 5:00 p.m. (EST )

M – F
Mail To:
HoMedics
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390

Email: cservice@homedics.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Homedics MT-CML Manual

Advertisement

Need help?

Need help?

Do you have a question about the MT-CML and is the answer not in the manual?

Questions and answers

Table of Contents