Related Manuals for Garmin TACX NEO 3M
Summary of Contents for Garmin TACX NEO 3M
- Page 1 TACX NEO 3M ® Quick Start Manual........2 Manuel de démarrage rapide ......16 Guía de inicio rápido ........31 Sổ tay hướng dẫn khởi động nhanh ....46...
- Page 2 TIP: The Tacx Training app includes trainer setup, videos, and software updates (page 10). • For best results, use the Tacx NEO 3M trainer with a firm mat or low pile carpet. Avoid soft and high pile carpet. You can use a training mat that is 181 x 92 cm (71.3 x 36.2 in.) or larger.
- Page 3 TIP: The trainer is heavy. You can unfold one side and lock it, and repeat for the other side. 2 Ensure both sides of the trainer lock into place. The indicator window is blue when the sides are properly locked. Quick Start Manual...
- Page 4 The trainer has pre-installed end cap supports for bikes with a 142 mm thru axle. NOTE: If you are using a 148 mm thru axle, you must swap out the end cap support using the blue tool. For more instructions, go to www.garmin.com/manuals/NEO3M. 1 Open the installation kit , and select the Thru-Axle 12mm end caps.
- Page 5 3 On your bike, shift to the smallest cassette gear. 4 Remove the rear wheel from your bike. NOTE: You should keep the bike and all of the parts within reach. 5 Place your bike on the trainer, making sure the chain is on the smallest sprocket of the trainer cassette.
- Page 6 • If you have a 135 mm quick release axle, go to step 5. 2 Open the installation kit , and select the NDS/130 QR end cap support and the blue tool. 3 Use the blue tool to remove the existing end cap support on the non-drive side. 4 Use the blue tool to install the NDS/130 QR end cap support.
- Page 7 9 Hand tighten the cap , leaving enough room for the bike frame. 10 On your bike, shift to the smallest cassette gear. 11 Remove the rear wheel from your bike. NOTE: You should keep the bike and all of the parts within reach. 12 Align your bike on the trainer, and place the chain on the smallest sprocket of the trainer cassette.
- Page 8 Positioning the Front Wheel Support Before you can position the front wheel support, you must attach your bike to the trainer. The two-sided front wheel support raises the front wheel of the bike for a natural cycling position and increased stability. The smaller side of the wheel support can hold a maximum tire width of 30 mm (1.18 in.).
Need help?
Do you have a question about the TACX NEO 3M and is the answer not in the manual?
Questions and answers