Advertisement
Quick Links
AEGIS TRI-POWER
UV LED CURING LAMP
LMP2008 OPERATION AND
MAINTENANCE INSTRUCTIONS
FEATURES
1. LENS
2. SUCTION CUP
3. BODY
4. ENDCAP
5. POWER PORT
6. BLUE INDICATION LIGHT
7. POWER SWITCH
8. POWER CABLE
9. RED INDICATOR LIGHT
10. 12V POWER PLUG
11. SOCKET
12 AC/DC CONVERTER
The LED UV Tri-Power Curing Lamp
uses 365 N-m wavelength to cure
resin during auto glass repair.
1
8
12
11
10
9
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Aegis LMP2008
Summary of Contents for Aegis LMP2008
- Page 1 AEGIS TRI-POWER UV LED CURING LAMP LMP2008 OPERATION AND MAINTENANCE INSTRUCTIONS FEATURES 1. LENS 2. SUCTION CUP 3. BODY 4. ENDCAP 5. POWER PORT 6. BLUE INDICATION LIGHT 7. POWER SWITCH 8. POWER CABLE 9. RED INDICATOR LIGHT 10. 12V POWER PLUG The LED UV Tri-Power Curing Lamp 11.
- Page 3 OPERATION To Use the Lamp Wear eye protection whenever you look into direct or reflected rays from any UV light source, because radiation from UV light can cause injury to eyes. Make sure the battery is fully charged (see NOTE 1: The lamp’s run time is approximately 150 minutes when used To Charge the Battery).
- Page 4 • Power cable and AC/DC converter: Connect the 12V power plug of the power cable to the Socket on the AC/DC converter. Then plug the other end of the power cable into the power port. Next, connect the AC/DC converter to an appropriate AC outlet (see specifications on converter), to begin charging (see Note NOTE 4: To use the AC/DC converter outside...
- Page 5 Slide out the old Suction Cups. Slide in the new suction cups. Make sure each cup’s tab points outward, for easy removal from the glass. Reinstall the endcap plate and secure by reinstalling the screws. Do not overtighten screws. Repeat steps 1-5 with the other endcap. To Replace the Battery From the Endcap with the Power Switch, remove the 4 screws using a #0 Philips...
- Page 6 If a problem develops during the warranty period, follow the instructions below to obtain warranty service. If inspection shows that the product has a defect, AEGIS will repair or replace the product without charge.
- Page 7 CONTACT INFORMATION AEGIS Tools International, Inc. 908 West Main St. Laurel, MT 59044 USA Email: contactus@wpg.com Phone: (1) 800-548-7341 or (1) 406-628-8231 www.AegisTools.com...
- Page 8 Aegis Tools by Wood’s Powr-Grip Co., Inc. | 908 West Main Street | PO Box 368 | Laurel, MT USA 59044 www.aegistools.com | orderdesk@wpg.com FRM9070 Rev. 0.1 / 02-24 Instructions LMP2008...
Need help?
Do you have a question about the LMP2008 and is the answer not in the manual?
Questions and answers