Homedics Shiatsu Air Pro FMS-350H Manual

Also See for Shiatsu Air Pro FMS-350H:

Instruction manual and warranty information (13 pages)

Table of Contents

Contents

1 OVERVIEW
2 Instructions for Use
3 Maintenance
4 IMPORTANT SAFETY INSTRUCTIONS
5 Documents / Resources
- 5.1 Download manual

Homedics Shiatsu Air Pro FMS-350H Manual

OVERVIEW

Instructions for Use

To reduce the risk of electric shock, this unit is equipped with a polarized plug (one blade wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

Plug into a 120-volt outlet.
It is highly recommended that you wear socks while using this foot massager. Do not use the unit with shoes.
Place massager on the floor in front of your chair or seat and place feet in massager.
To activate massage, press the POWER button once (Fig. 1). The button will illuminate white to confirm your selection. The unit will start with both air and knead at low intensity.

Air Intensity Button

Pressing the AIR INTENSITY button will allow you to adjust the intensity of the air pressure, how firmly it squeezes your feet. (Fig. 2).
Press MODE button until AIR INTENSITY button is illuminated.
When first turned on, AIR INTENSITY will begin in the lowest setting with the button illuminated dull blue.
Pressing the button again will change the foot pressure to medium, indicated by a brighter blue.
Pressing the button a third time will change the pressure to high, indicated by the brightest blue.
Pressing the button once more will return the pressure to its lowest setting.

Mode Button

Pressing the MODE button starts the unit with both air and knead in low intensity. Both sides of the button will be illuminated (Fig. 3).
Pressing the button again will change the unit to air only. The left side of the MODE button will illuminate blue.
Pressing the button a third time will change the unit to knead only. The right side of the MODE button will illuminate green.
Pressing the button once more will return the unit to air and knead. AIR INTENSITY, MODE, and KNEAD INTENSITY buttons will all be illuminated.

Knead Intensity Button

Pressing the KNEAD INTENSITY button will allow you to adjust the intensity of the massaging mechanism (Fig.4).
Press MODE button until the KNEAD INTENSITY button is illuminated.
When first turned on, KNEAD INTENSITY will begin in the lowest setting with button illuminated dull green.

Pressing the button again will change the massage intensity to medium, indicated by a brighter green.
Pressing the button a third time will change the intensity to high, indicated by the brightest green.
Pressing the button once more will return the intensity to its lowest setting.

To avoid injury and irreparable damage, always remain seated when using massager. Never stand on the unit.

Heat Button

To activate soothing heat, first select AIR or KNEAD. Then simply press the HEAT button and it will illuminate red (Fig. 5).
To turn heat off, press the button again and the red light will turn off.
NOTE: For your safety, heat cannot be turned on unless air and/or knead program is selected. When finished, turn the unit "OFF" and unplug.

Maintenance

To Store
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects. To avoid breakage, DO NOT wrap the power cord around the unit. DO NOT hang the unit by the controller cord.

To Clean
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly damp sponge. NEVER allow water or any other liquids to come into contact with the unit.

DO NOT immerse in any liquid to clean.
Never use abrasive cleaners, brushes, or strong chemicals that might or might not be flammable and/or damaging to the product to clean.
DO NOT attempt to repair the massager. There are no user serviceable parts. For service, contact the Consumer Relations telephone number listed in the warranty section.
NOTE: HoMedics is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such

IMPORTANT SAFETY INSTRUCTIONS

WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING

TO REDUCE THE RISK OF ELECTRIC SHOCK:

ALWAYS unplug this appliance from the electrical outlet immediately after using and before cleaning.
DO NOT reach for an appliance that has fallen into water. Unplug it immediately.
Never use pins or other metallic fasteners with this appliance.

TO REDUCE THE RISK OF BURNS, ELECTRIC SHOCK, FIRE OR INJURY TO PERSONS:

An appliance should NEVER be left unattended when plugged in. Unplug from outlet when not in use, and before putting on or taking off parts or attachments.
Not for use by children.
Close supervision is necessary when this unit is used by, on, or near children, invalids, or disabled persons.
DO NOT use outdoors.
Use this appliance only for its intended use as described in this manual. DO NOT use attachments not recommended by HoMedics; specifically any attachments not provided with the unit.
DO NOT carry this appliance by the supply cord or use cord as a handle.
NEVER operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return it to HoMedics Service Center for examination and repair.
Keep the cord away from heated surfaces.
NEVER operate the appliance with the air openings blocked. Keep the air openings free of lint, hair, and the like.
NEVER drop or insert any object into any opening.
DO NOT operate where aerosol (spray) products are being used or where oxygen is being administered.

DO NOT stand on or in appliance. Use only while seated.
DO NOT operate under a blanket or pillow. Excessive heating can occur and cause fire, electric shock, or injury to persons.
To disconnect, turn all controls to the "OFF" position, then remove plug from outlet.
Use heated surfaces carefully. May cause serious burns. DO NOT use over insensitive skin areas or in the presence of poor circulation. The unattended use of heat by children or incapacitated persons may be dangerous.

All servicing of this massager must be performed by authorized HoMedics service personnel only.

SAVE THESE INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING.
Note: There is a 15 minute auto shut off on the unit for your safety.

This product is not intended for medical use. It is intended only to provide a luxurious massage.
Consult your doctor prior to using this product, if
- You are pregnant
- You have a pacemaker
- You have any concerns regarding your health
Not recommended for use by Diabetics.
NEVER leave the unit unattended, especially if children are present.
NEVER cover the unit when it is in operation.
If at any time soreness, rash, or pain occurs, discontinue use and consult your physician.
DO NOT use this product for more than 15 minutes at a time.
Extensive use could lead to the product's excessive heating and shorter life. Should this occur, discontinue use and allow the unit to cool before operating.
NEVER use this product directly on swollen or inflamed areas or skin eruptions.
DO NOT use this product as a substitute for medical attention.
DO NOT use this product before bed. The massager has a stimulating effect and can delay sleep.
NEVER use this product while in bed.
This product should NEVER be used by any individual suffering from any physical ailment that would limit the user's capacity to operate the controls.
This product should NOT be used by children or invalids without adult supervision.
This product is intended for household use only.
This product is not intended for use in automobiles.

Attention California Residents:

This product contains chemicals known to the State of California to cause cancer, birth defects and other reproductive harm.

NOTE: This unit may turn off after an extended period of use. If your unit turns off (LED may remain on). If your unit overheats, unplug the unit and let cool for 30 minutes before plugging in again and continuing use.