Pioneer A-616 Operating Instructions Manual

STEREO AMPLIFIER
A-616
A=717
Opera ting
Instructions
The illustration shows model A-717.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know how to operate
your model properly. After you have finished reading the instructions, put them
away in a safe place for future reference.
In some countries or regions, the shape of the power plug and power outlet may
sometimes differ from that shown in the explanatory drawings. However, the method
of connecting and operating the unit is the same.
WARNING: To PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
IMPORTANT NOTICE
{For U.S. and Canadian models]
The serial number for this equipment is located
on the rear panel. Piease write this serial number
on your enclosed warranty card and keep it in a
secure area. This is for your security.
[For Canadian model]
CAUTION: to PREVENT ELECTRIC SHOCK
DO NOT USE THIS (POLARIZED) PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
ATTENTION: pour PREVENIR LES CHOCS
ELECTRIQUES EN PAS UTILISER CETTE FICHE
POLARISEE AVEC UN PROLONGATEUR UNE
PRISE DE COURANT OU UNE AUTRE SORTIE DE
COURANT, SAUF SI LES LAMES PEUVENT ETRE
INSEREES A FOND SANS EN LAISSER AUCUNE
PARTIE A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
Mains voltages in Saudi Arabia are 127V and 220V
only. Never use this model with 110V setting in
Saudi Arabia. :
The line voltage selector switch is on the rear panel. Before
your model is shipped from the factory, this switch is set to the
power requirements of the destination. Check that it is set
properly before plugging the power cord into the AC wall
socket. If the voltage is not properly set or if you move to an
area where the voltage requirements differ, adjust the selector
switch as follows.
1. Use a medium-size screwdriver.
2. Insert the screwdriver into the groove on the voltage
selector, and adjust so that the tip of the arrow points to the
voltage value of your area.
VOLTAGE SELECTOR |
120-127v How
240v 220v
.
a
_
Medium-size screwdriver
Y PIONEER'
The future of sound and vision.