NAD SR8 - ADDENDUM User Manual

Remote control library

Download this manual

The SR 8 can store a different library of default NAD codes for each of its DEVICE SELECTOR "pages. " If

the original default library does not control your NAD CD player, DVD player or other components,

follow the procedure below to change the library code. Refer as well to the table below for a list of

applicable NAD Library Codes with their corresponding NAD models.

LOAD ANOTHER LIBRARY CODE

Example: Load NAD DVD Player T 517 library codes to SR 8's "CD" device.

1 Press and hold [CD] in the DEVICE SELECTOR section of SR 8.

2 While holding down the device button (CD), press "2" and "2" using SR 8's numeric buttons. "22" is

the corresponding library code for T 517.

3 Press [ENTER] while still holding down the device button (CD). The CD device selector will flash

once to indicate that the library input is successful. Both the device selector button (CD) and

[ENTER] can now be released.

RESET THE SR 8 TO ITS DEFAULT SETTINGS

The SR 8 can be restored to its factory settings, including default libraries, by the following procedures

1 Press and hold [ON] and [DELETE/CLEAR] buttons for about 10 seconds until the AMP device

button lights up.

2 Within two seconds of the AMP device button lighting up, release both buttons. If the reset mode

is successful, the [CD] device button will flash twice.

TABLE OF LIBRARY CODES APPLICABLE TO SR 8 REMOTE CONTROL

LIBRARY CODE

NAD PRODUCT DESCRIPTION

Default library for "AMP" page

Zone 2

Default library for "CD" page; C 515BEE, C 545BEE, C 565BEE

T 535, T 585, M55, DVD section of L 54, VISO TWO, VISO FIVE

T 513, T 514, T 515, T 517

T 587

IPD 2

Default library for "TUN" page; Tuner section of C 725BEE, T 175, T 737, T 747, T 755, T 765,

T 775, T 785

C 422, C 425

C 445

NOTE

The SR 8 may not necessarily contain all the control buttons applicable for the above-mentioned

NAD products. Use the prescribed remote control of the specific NAD product for a full compliment

of the applicable remote control buttons.

USING THE SR 8 REMOTE CONTROL LIBRARY