Page 1
SUPPORT INFORMATION Intrusion 2020-12-10 SPC – WSMK Guidance document ▪ Installation ▪ Battery Life ▪ Enrolment Process ▪ Servicing and Commissioning ▪ Device alarm management...
Page 2
SUPPORT INFORMATION Installation • Do not install on an uneven surface, could cause tamper issues. • Test the signal strength for the location of the WSMK prior to completing the fixing process. • SW 3.9.1 and older versions have the facility to isolate the tamper from the WSMK. •...
Page 3
SUPPORT INFORMATION Arrow on template and mounting bracket. Note the detector will fit into the mounting bracket in THREE different positions and several insertions may be required to have the detector in the correct orientation. The correct orientation is indicated by the green arrow, Fig:2 Fig:3 below.
Page 4
SUPPORT INFORMATION Battery Life • Within the SPC configuration, ensure the supervision time is set to the default time of 7 minutes. If the supervision time is greater than 7 minutes, check that the prevent set time, in wireless setting menu, is it may need to be extended to allow for supervision failure(s). •...
Page 5
SUPPORT INFORMATION Servicing & Testing • Test using the SmokeSabre test gas Art., Nr. N54591-Z148-A100 or operating the test button Fig: 5 A • Do not use real smoke. • Operation of the detector will activate the local siren within the smoke alarm and all associated audible &...
Page 6
SUPPORT INFORMATION Do’s & Don’ts • Do not install the detector with 3m of a bathroom, laundry or any other location that can create condensation. • Do not install the detector in a kitchen, garage, workshop, or any other location that can generate products of combustion.
Page 7
SUPPORT INFORMATION If you have any questions, please contact our Technical Competence Centre. Contact details can be found on our website.
Need help?
Do you have a question about the SPC WSMK and is the answer not in the manual?
Questions and answers