NAD C316BEE Owner's Manual page 7

7 TONE CONTROLS: The NAD C 316BEE is fitted with BASS and TREBLE
tone controls to adjust the tonal balance of your system. The 12 o'clock
position is "flat" with no boost or cut, and an indent indicates this
position. Rotate the control clockwise to increase the amount of Bass or
Treble. Rotate the control counterclockwise to decrease the amount of
Bass or Treble. The Tone controls do not affect recordings made using
the Tape output.
8 TONE DEFEAT: The TONE DEFEAT switch bypasses the tone control
section of the C 316BEE. If the Tone Controls are not normally used and
left in the 12 o'clock position, then it is advisable to switch out the Tone
Control section altogether by using this switch. In the 'out' position, the
Tone Control circuits are active; pushing the TONE DEFEAT switch 'in'
bypasses the Tone Control section.
9 BALANCE: The BALANCE control adjusts the relative levels of the left
and right speakers. The 12 o'clock position provides equal level to the
left and right speakers. A detent indicates this position. Rotating the
control clockwise moves the balance towards the right. Rotating the
control counterclockwise moves the balance to the left. The BALANCE
control does not affect recordings made using the Tape output.
10 VOLUME: The VOLUME control adjusts the overall loudness of the
signals being fed to the loudspeakers or headphones. Turn clockwise to
increase the volume setting; counter clockwise to lower it. The VOLUME
control does not affect recordings made using the Tape output.
IDENTIFICATION OF CONTROLS
FRONT PANEL
7