Download Print this page
Mattel HotWheels RC AARON WHEELZ FOTHERINGHAM GYD26T Instructions
Mattel HotWheels RC AARON WHEELZ FOTHERINGHAM GYD26T Instructions

Mattel HotWheels RC AARON WHEELZ FOTHERINGHAM GYD26T Instructions

Advertisement

Quick Links

Keep these instructions for future reference as they contain important information.
IMPORTANT: Please read all instructions before operating your wheelie chair.
HVIN: GYD26T (
), GYD26R (
CAUTION:
Surfaces may become hot and cause burns if electronics get wet.
To prevent entanglement, keep all hair away from moving parts.
Adult supervision is recommended when the wheelie chair is being operated
The wheelchair and helmet logo is a registered trademark of WCMX International LLC.
©2021 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services
1-800-524-8697. Mattel U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK. Mattel Australia Pty. Ltd., 658 Church St., Richmond, Victoria, 3121.
Consumer Advisory Service - 1300 135 312. Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard, Johannesburg 2196. Mattel East Asia Ltd., Room 503-09,
North Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China. Tel.: (852) 3185-6500. Diimport & Diedarkan Oleh: Mattel Continental Asia Sdn Bhd. Level 19,
Tower 3, Avenue 7, No. 8 Jalan Kerinchi, Bangsar South, 59200 Kuala Lumpur, Malaysia.
1: CONTENTS
AARON WHEELZ
WHEELIE CHAIR
2: FEATURES
BACK VIEW
ON/OFF SWITCH
CHARGE PORT
3: SET UP
A. REMOTE CONTROLLER BATTERY INSTALLATION
1. Unscrew the battery cover with a Phillips head screwdriver (not included).
2. Install 2 AA (LR6) 1.5V alkaline batteries (not included) with polarity (+/-) as
shown inside the battery compartment. For longer life, use alkaline batteries.
3. Replace battery cover and tighten screw.
INSTRUCTIONS
)
CHARGE CORD
USB Charger not included.
REMOTE CONTROLLER
Colors and decorations may vary.
LED INDICATOR
X
CARDBOARD RAMP
LED INDICATOR
DRIVING
CONTROLS
PAIRING BUTTON
6+
GYD26-0970-G2-DOM
STICKER SHEET
BOOST BUTTON
ALIGNMENT BUTTONS
®

Advertisement

loading
Need help?

Need help?

Do you have a question about the HotWheels RC AARON WHEELZ FOTHERINGHAM GYD26T and is the answer not in the manual?

Questions and answers

Summary of Contents for Mattel HotWheels RC AARON WHEELZ FOTHERINGHAM GYD26T

  • Page 1 1-800-524-8697. Mattel U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK. Mattel Australia Pty. Ltd., 658 Church St., Richmond, Victoria, 3121. Consumer Advisory Service - 1300 135 312. Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard, Johannesburg 2196. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
  • Page 2 4. Replace batteries in the remote controller if the wheelie chair does not respond well after a recharge. AA (LR6) 1.5V B. CHARGING THE WHEELIE CHAIR The wheelie chair is powered by a permanently installed Lithium-ion (Li-ion) battery, and it must be fully charged before first use.
  • Page 3 CONTROLS BOOST FORWARD/BACKWARD LEFT/RIGHT STEERING TIP: Tilt the wheelie chair back and try pulling off different tricks with the driving controls! NOTE: • Operating range of the remote controller is up to 25 m (82 ft). • The wheelie chair and remote controller will go into sleep mode if left idle for approximately 5 minutes. To resume normal play, press and hold the remote controller’s pairing button until the LED lights up again.
  • Page 4 3) Point your remote controller up, and not down toward your wheelie chair. If your wheelie chair gets too far away, it won't work properly. 4) Don’t store your wheelie chair near heat or in direct sunlight. Always turn switches OFF and remove all batteries from remote controller before storage. 5) Don't drive your wheelie chair in sand or through water or snow.

This manual is also suitable for:

Hotwheels rc aaron wheelz fotheringham gyd26r