ZyXEL Communications ZYWALL2 ET 2WE User Manual page 109

LABEL
Drop Type the AT Command string to drop a call. "~" represents a one
second wait, for example, "~~~+++~~ath" can be used if your modem
has a slow response time.
Answer Type the AT Command string to answer a call.
Drop DTR When Select this check box to have the ZyWALL drop the DTR (Data
Hang Up Terminal Ready) signal after the "AT Command String: Drop" is sent
out.
AT Response Strings
CLID Type the keyword that precedes the CLID (Calling Line Identification)
in the AT response string. This lets the ZyWALL capture the CLID in
the AT response string that comes from the WAN device. CLID is
required for CLID authentication.
Called ID Type the keyword preceding the dialed number.
Speed Type the keyword preceding the connection speed.
Call Control
Dial Timeout Type a number of seconds for the ZyWALL to try to set up an
(sec) outgoing call before timing out (stopping).
Retry Count Type a number of times for the ZyWALL to retry a busy or no-answer
phone number before blacklisting the number.
Retry Interval Type a number of seconds for the ZyWALL to wait before trying
(sec) another call after a call has failed. This applies before a phone
number is blacklisted.
Drop Timeout Type the number of seconds for the ZyWALL to wait before dropping
(sec) the DTR signal if it does not receive a positive disconnect
confirmation.
Call Back Delay Type a number of seconds for the ZyWALL to wait between dropping
(sec) a callback request call and dialing the corresponding callback call.
Apply Click Apply to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.
WAN Screens
Table 6-10 Advanced Setup
DESCRIPTION
ZyWALL 2 Series User's Guide
EXAMPLE
~~+++~~ath
CONNECT
ata
NMBR
60
0
10
20
15
6-25