Troubleshooting - ZyXEL Communications ZYWALL 1050 - V1.00 EDITION 1 Quick Start Manual

Internet security appliance
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Port
Interface Zone IP Address and DHCP Settings
1
ge1
2, 3
ge2, ge3
4, 5
ge4, ge5
DIAL BACKUP aux
CONSOLE
N/A
Label
1~5
DIAL BACKUP, CONSOLE RS-232
Note: The USB ports, extension card slots, and hard disk slot are reserved for future use.

7 Troubleshooting

Problem
Corrective Action
None of the LEDs
Make sure that you have the power cord connected to the ZyWALL and plugged in to an
turn on.
appropriate power source. Make sure you have the ZyWALL turned on. Check all cable
connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you should
contact your local vendor.
LAN
192.168.1.1, DHCP server enabled Protected LAN
WAN DHCP clients
DMZ None, DHCP server disabled
None None
None None
Type
Cable to Use
RJ-45
8-wire Category 5e or above Ethernet cable
RS-232
ENGLISH
Suggested Use With Default Settings
Connections to the Internet
Public servers (such as web, e-mail and
FTP)
Auxiliary modem
Local management
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zywall 1050

Table of Contents