Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Kyocera DG11XR
Summary of Contents for Kyocera DG11XR
- Page 1 DG11XR 69801277-00 ZAF 09-22...
- Page 2 Push Attach Protruding section Remove - 1 -...
- Page 3 Lamp display Table 1 Display mode Lamp color Flashing speed Meaning Stand-by Green Flashing The charger is plugged into the outlet. Charging Solid Charging 80％ charged Flashing 80% fully charged Charged Green Solid Charging completed The battery pack is too hot for charging. Waiting for cool down Green •...
- Page 4 Grinding Sanding Cutting-off - 3 -...
- Page 5 15～30° - 4 -...
- Page 6 THANK YOU FOR BUYING OUR PRODUCT. c) Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power To ensure your safety and satisfaction, carefully read source and/or battery pack, picking up or carry- through this OWNER’S MANUAL before using the product. ing the tool.
- Page 7 5) Battery tool use and care f) Threaded mounting of accessories must match a) Recharge only with the charger specified by the the grinder spindle thread. For accessories manufacturer. A charger that is suitable for one type mounted by flanges, the arbour hole of the accessory must fit the locating diameter of the of battery pack may create a risk of fire when used flange.
- Page 8 Kickback and Related Warnings f) Do not use worn down wheels from larger power tools. Wheel intended for larger power tool is not Kickback is a sudden reaction to a pinched or snagged suitable for the higher speed of a smaller tool and rotating wheel, backing pad, brush or any other may burst.
- Page 9 8. ACCESSORIES : The use of accessories or attach- STANDARD ACCESSORIES ments other than those recommended in these in- Lock-nut wrench, Auxiliary handle, Charger, Battery pack, structions might present a hazard. Carrying case 9. REPLACEMENT PARTS : When servicing use only identical replacement parts.
- Page 10 HOW TO CHARGE (Fig. 3) INSTALLATION OF SANDING DISC (Fig.5,6) The charger (13) may become a little warm while charging, 1. Attach the disc flange (5), sanding pad (17), sanding but this does not affect its performance. disc (18) and clamp nut for sanding disc (19) to the spindle shaft (4).
- Page 11 Table 2 Lamp indication Situation Measures Turn off the switch and remove the battery, then The tool is overload. remove the cause of overload. The Tool and/or the battery Turn off the switch and remove the battery, overheated. Remove the battery from the tool and wait for the The temperature inside the 3 lamps flashing battery to go back to room temperature.
Need help?
Do you have a question about the DG11XR and is the answer not in the manual?
Questions and answers