Advertisement
Quick Links
Advertisement
Related Manuals for Speco SB11M
Summary of Contents for Speco SB11M
- Page 1 SB11M Quick Start Guide...
- Page 2 Phone: 1-800-645-5516 option 3 Email: techsupport@specotech.com Important Safeguards and Warnings Speco Technologies assumes no liability or responsibility for any fires or electrical shock caused by improper handling or installation. Speco Technologies is not liable for any problems caused by unauthorized modifications or attempted repair.
- Page 3 1 Introduction Interfaces and Indicators The picture below is for reference only. Description Description Power indicator Reset Power switch System disk running indicator Rear Panel Instructions The picture below is for reference only.
- Page 4 2 Login & Network Configuration Login Before starting, please make sure network cable, monitor and power are connected. After the server is started, the following window will appear as shown below. ① Enter username and password (the default username is admin; the default password is 1234).
- Page 5 Network Configuration After logging in, enter Local ConfigurationNetwork Config interface as shown below. Set the network parameter according to the actual condition. It is recommended to enable “IP Group” and the network mode is set to “Adaptive Load Balancing”. Then you can add devices and set other parameters as needed.
Need help?
Do you have a question about the SB11M and is the answer not in the manual?
Questions and answers