Before Using This Product Before Using This Product ....2 Connecting the Unit ......5 Thank you for purchasing this PIONEER product. Before attempting operation, be sure Visit our website .......... 2 Connection Diagram ........5 to read this manual.
Electrical shock could result. Also, amplifier Do NOT install or use your Pioneer amplifier by wiring speakers rated at 4 $ (or lower) and speaker damage, smoke, and overheating could result from contact with liquids.
Setting the Unit Gain Control Adjusting the gain controls A and B will help match the output of the car stereo to the Pioneer amplifier. Normally, set the gain controls to the NORMAL position. If the output is low, even when the volume of the car stereo is turned up, turn these controls clockwise.
MAN-GM-6300T-GB.fm Page 5 Thursday, November 16, 2006 4:23 PM Connecting the Unit ! CAUTION Connection Diagram • Disconnect the negative (–) terminal of the battery to avoid the risk of short-circuit and damage to the unit. • Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive Fuse (30 A) tape around it where they lie against metal parts.
MAN-GM-6300T-GB.fm Page 6 Thursday, November 16, 2006 4:23 PM Connecting the Unit Connecting the Power Terminal ! WARNING Failure to securely fasten the battery wire to the terminal using the terminal screws • Always use the special red battery and ground wire [RD-223], which is sold could cause the terminal area to overheat and could result in damage and injury separately.
MAN-GM-6300T-GB.fm Page 7 Thursday, November 16, 2006 4:23 PM Connecting the Unit Using the Speaker Input Connecting the Speakers and Input Wires Connect the car stereo speaker output wires to the amplifiers using the supplied The speaker output mode can be four-channel, three-channel (stereo + mono) or two- speaker input connector.
MAN-GM-6300T-GB.fm Page 8 Thursday, November 16, 2006 4:23 PM Connecting the Unit Installation ! CAUTION Two-channel mode (Stereo) • Do not install in: – Places where it could injure the driver or passengers if the vehicle stops suddenly. RCA input jack A –...
MAN-GM-6300T-GB.fm Page 9 Thursday, November 16, 2006 4:23 PM Installation Specifications Example of installation on the floor mat or on the Power source ............... 14.4 V DC (10.8 V to 15.1 V allowable) Grounding system ...................... Negative type chassis Current consumption ..............35.0 A (at continuous power, 4 $) Average current drawn* ...............
MAN-GM-6300T-GB.fm Page 10 Thursday, November 16, 2006 4:23 PM Additional information • This unit is equipped with a protective function to prevent malfunction of the unit Power Power itself and speakers from too much output, improper use or improper connection.
Need help?
Do you have a question about the GM-6300T and is the answer not in the manual?
Questions and answers