PROEM ER2C4 A39 Programming Manual

Remarks
- There are « master » and « slave » remote controls
- Only "master" remote controls can teach their code to other remote controls.
Programming of your new remote control:
If it is a « master » model:
1. Press both buttons on your new remote control simultaneously.
2. The screen of the receiver displays:
N S 0
M E M
00000 is the serial number of your « master » remote control. The factory setting is 11111. Type your
serial number in the following manner :
- You can change the figure with the left button
- You validate the figure with the right button
- Press the right button on your new remote control (YES). The screen of the receiver displays
« MISE A JOUR OK »
3. Your new remote control is programmed.
If it is a « slave » model:
1. The screen of the receiver displays:
MENU
MEMO EMETTEUR ?
Validate with the right button of the "master" remote control.
2. The screen of the receiver displays:
MEMO EMMETTEUR
EMETTEUR N°001
Type the number of your remote control in the same way than before (2 if it is the second
recorded remote control).
Validate with the right button of your « master » remote control.
http://www.remotecontrol-express.com
Programming Manual
PROEM ER2C4 A39 - ER4C4 A39
0 0 0 0
O M A
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
A R L 1/2
I T R E
C N A
?