PROEM ER2C4ACS Programming Manual

SOMFY Mitto RTR - PROEM ER2C4ACS – PROEM ER4C4ACS
Programming of your new remote control:
The programming method depends on the gate you own

On a PASSEO 520 /550 /570 /600 /630 /650 gate

1. Pose your new remote control on the target graved on the hood of your receiver. It is located
next to your motor.
2. Press the button you wish to program on your new remote control. Keep it pressed down.
The LED light on the receiver blinks. Let the button go.
3. Wait 10 seconds.
4. Your new remote control is programmed.

On a PASSEO 400 /500 /S200 /230 /400 /524 gate

1. Approach your control panel (diagram above).
2. Check that the button B1 is in the ON position and that the LED light V1 illuminates.
3. Press the button you wish to program on your new remote control. Keep it pressed down.
The LED light V4 blinks.
4. While keeping the button on your new remote control pressed down, press the button B4.
Keep it pressed down as well. The LED light V4 blinks and then remains lit constantly.
5. Let the buttons go.
6. Wait 10 seconds.
7. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151