FlashPath Floppy Adapter for MultiMediaCard
Troubleshooting
This is a basic "common" troubleshooting list. If your problem isn't solved by those
listed, Please visit our web site
on compatibility issues as well as the latest software drivers. Or see the back page for
contacting Tech Support.
SYMPTOM
The FlashPath isn't being
recognized by the computer
Or
I'm getting "The disk in drive A
is not formatted" error.
Error writing to the FlashPath,
or can't format the MultiMedia
Card in the FlashPath.
The FlashPath works with
MultiMediaCards, but does not
seem to recognize SD
(Secure Digital) cards.
Page 10
http://www.delkin.com
for FAQs and current information
CAUSE
The card was accessed before
it was recognized by the
system.
The FlashPath has gone into
sleep mode.
The MultiMidiaCard isn't
inserted in the proper direction
or isn't inserted fully.
The batteries are not loaded or
are loaded in the wrong
direction.
The batteries are depleted.
The driver sofware may not
have been properly installed,
or system wasn't restarted
after installation.
Some anti-virus programs
interfere with FlashPath
functions.
On Macintosh systems,
FlashPath is read-only.
The current FlashPath does
not have the nine-pin connec-
tor required to access Secure
Digital cards.
Delkin Devices User's Manual
DDFLSPTH2-AD
SOLUTION
Eject the FlashPath, wait a
second and reinsert it.
Eject the FlashPath, wait a
second and reinsert it.
Recheck that the MultiMedia
Card is properly inserted.
Check that batteries are
installed correctly.
Install new batteries.
Reboot the computer. If you
get the same results, reinstall
the driver software.
Disable anti-virus scans during
COPY, CREATE, RANAME, or
similar operations. In some
cases, you may need to
temporarily disable all anti-
virus software while using
FlashPath.
Use your MultiMidiaCard digital
device to format or delete files.
You will need an approved
Secure Digital device to
access SD cards. The
FlashPath-MMC is designed
for MultiMediaCards.
Need help?
Do you have a question about the MultiMedia Card to Floppy Disk Adapter and is the answer not in the manual?