Advertisement
Table of Contents
Contents
BroadLink SP4M-US Manual
Overview
Indications
| Status | Indication |
| Flashes quickly (5 times/sec) | Device is in Smart Setup mode (waiting to be added). |
| Flashes intermittently | Device is in AP (NC)APP) Setup mode (waiting to be added). |
| Flashes slowly then off | Device is being set up and added to network |
| Flashes slowly continuously | Device is failed to connect to network or disconnected from network |
| ON/OFF | Device is switched on/off |
- Reset for AP (NoAPP) setup
When the device is in any conditions, press and hold the power (reset) button for 5s until the LED indicator flashes intermittently. DO NOT hold longer than 10s, otherwise it will go to Smart Setup mode. - Reset for Smart Setup
When the device is in any conditions, press and hold the power (reset) button for 10s until the LED indicator flashes quickly.
Troubleshooting
- I couldn't get popup landing page, what can I do?
After your phone is connected to "BroadLink WiFi Device" wireless network, open your phone web browser and input the address: "noapp.com". - I couldn't find home Wi-Fi network in landing page, what can I do?
You may not have 2.4GHz Wi-Fi network in your home, check the Wi-Fi settings from your router manufacturer - I couldn't get verification code by email, what can I do?
Check your spam in email. If you are using email client, please try to check your email on webpage.
Important notices
- For indoor use in dry environment only.
- DO NOT connect to appliances before the device is added in App.
For more promotions and supports
BroadLink International
web: www.ibroadlink.com
e-mail: support@ibroadlink.com
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the SP4M-US and is the answer not in the manual?
Questions and answers