Download Print this page

Important Safety Instructions - LENCO TS-10 Instruction Manual

Advertisement

Important Safety Instructions

Safety
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near
water.
6 Clean only with dry cloth.
7 Do not block any ventilation
openings. Install in accordance
with the manufacturer's instructions.
8 Do not install near any heat
sources such as radiators, heat
registers, stoves, or other apparatus
(including amplifiers) that produce
heat.
9 Protect the power cord from being
walked on or pinched particularly
at plugs,convenience receptacles,
and the point where they exit from
the apparatus.
10 Unplug this apparatus during
lightning storms or when unused for
long periods of time.
11 Refer all servicing to qualified
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such
as power-supply cord or plug is
damaged, liquid has been spilled
or objects have fallen into the
apparatus, the apparatus has been
exposed to rain or moisture, does
not operate normally, or has been
dropped.
12 Unit shall not be exposed to
dripping or splashing.
13 Do not place any sources of
danger on the apparatus (e.g.
liquid filled objects, lighted candle).
14 The mains plug is used as the
disconnect device, the disconnect
device shall remain readily
operable.
Warning
1 Before operating this system, check
the voltage of this system to see if it
is identical with the voltage of your
local power supply.
2 Do not place this unit close to
strong magnetic field.
3 If the system is brought directly
from a cold to a warm location,
or is placed in a very damp room,
moisture may condense on the
lens inside the player. Should this
occur, the system will not operate
properly. Leave the system turned
on for about an hour until the
moisture evaporates.
4 Should any solid object or liquid fall
into the system, unplug the system
and have it checked by qualified
personnel before operating it any
further.
5 Do not attempt to clean the unit
with chemical solvents as this might
damage the finish. Use a clean, dry
or slightly damp cloth.
6 When removing the power plug
from the wall outlet, always pull
directly on the plug, never yank on
the cord.
2

Advertisement

loading