Usb Operation - LENCO SCD-30 Instruction Manual

Note on CD-R/RW discs
- Because of non-standardized format definition/ production of CD-R/RW, playback quality and performance are not
guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance,
writing software, media ability, etc.
- Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
PROGRAMMED CD OPERATION
FOR NORMAL COMPACT DISC PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order. Up to 20 tracks can be programmed.
1. Program mode works in STOP mode only.
2. Holding "PROGRAM/MEMORY" button. The "PROG" icon will be turned on. "000 P01" will be shown with "000"
flashing. "000" represents track number and "P01" represents program location number.
3. Press TUNE +/NEXT or TUNE - /BACK to select the required track number.
4. Press PROGRAM/MEMORY button to confirm the track number. The display will show the next
program number "000 P02:". The track number will be flashing again and waiting for track number input.
5. Repeat steps 3 and 4 until all the desired tracks has been programmed or all the
program memories have been used. It will loop back to P01 after all the program
memories have been used. Same track number can be programmed more than once.
6. Press ENTER/PLAY/PAUSE button to playback.
7. To clear the programmed tracks, first press PROGRAM/MEMORY button
for 2 seconds to enter program mode.
8. Press STOP key to clear all the programmed memories.
FOR MP3/WMA/USB PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order. Up to 20 tracks can be programmed.
1. Program mode works in STOP mode only.
2. Press "PROGRAM/MEMORY" button for 2 seconds to enter program mode. The "PROG" icon will be turned on.
"00000 P01" will be shown with "00" flashing. "000" represents track number and "P:01" represents program location
number.
3. Press the TUNE +/NEXT or TUNE - /BACK button to select the desired folder.
4. Press TUNE +/NEXT or TUNE - /BACK to select the required track number.
5. Press PROGRAM/MEMORY button to confirm the track number. The display will show the next
program number "000 P02". The track number will be flashing again and waiting for track number input.
6. Repeat steps 3 and 4 until all the desired tracks has been programmed or all the
program memories have been used. It will loop back to P01 after all the program
memories have been used. Same track number can be programmed more than once.
7. Press ENTER/PLAY/PAUSE button to playback.
8. To clear the programmed tracks, first press PROGRAM/MEMORY button
for 2 seconds to enter program mode.
9. Press STOP key to clear all the programmed memories.
USB OPERATION
1. Connect USB into the USB input of the system.
2. Press "FUNCTION" button repeatedly until "UDISK" is shown on the display. After entered the corresponding mode,
the corresponding icon will be lit up.
3. The unit will start to read the media and to start the playback automatically.
4. ID3 function can be enable/disable in the "MENU" function.
USB connector does not support connection with USB extension cable and it is not designed for communication
with computer directly.
GB 4
CD display
MP3/WMA/USB display