Advertisement
INSTALLATION
3. Remove the Bracket from headrest and loosen the two screws by using the
screwdriver, then place the two plastic tubes (3) on the holes that you just selected,
then adjust them to proper position as shown in diagram below.
4. Install the base on the poles of the headrest and adjust to proper position, then
use four screws (ø3x10 (4) to fix the base 1 and base 2.
5. Install the headrest with the base and rotate the Mounting Bracket to the car seat
in proper position, then use the screwdriver to fasten the two screws to fix the
base.
(3) Plastic tube
(1)
(4) Screw
(2)
GB-6
Advertisement
