Summary of Contents for Imperial Select 10 1900-10
Page 1
Slim Line—N1900 Select 10—1900-10 Installation Instructions & Warranty Information 425 Apollo Street Brea, CA 92821 www.imperialhoods.com (800) 851-4192 DO NOT THROW AWAY, PROPERTY OF THE HOME OWNER! Unit is to be hardwired. Adding a Power Cord is not UL approved and will void the warranty.
Page 2
NOT prevent fires. Fires are most often cause by excessive grease build up.) DISCLAIMER- Imperial assumes no liability regarding the improper installation or misapplication of its products. It is the installer’s responsibility to check for proper installation. Under no circumstances will Imperial be liable for any labor charged or travel time incurred for installation of its products.
Page 3
Slim Line Series Installation Details: MODELS MODELS MODELS MODELS N1900SD4 N1900BP1 N1900BP N1900PS N1900SD2 CABINET: Be sure that the cabinet bottom is level, side to side and front to rear. BP, SD4, SD2: Cut an 8” x 8” hole in the bottom of the cabinet, 3/4” in from the rear wall and on center line.BP1: Cut an 8”...
Page 4
Select 10 Series Installation Details: MODELS MODELS MODELS 1900SD4-10 1900PS-10 1900PSB-1 (B INDICATES BAFFLE FILTERS) CABINET: Be sure that the cabinet bottom is level, side to side and front to rear. SD4 & PS models: Cut an 8” x 8” hole in the bottom of the cabinet, 3/4”...
Page 5
Installation Instructions for 1900-10 ONLY Wall Mounting application. From bottom of hood, measure 10” up and draw a line. Take “U” shape installation bracket and line the bottom of the bracket up with the line (center bracket left to right) install bracket using #10 x 2-1/2”...
Page 6
Imperial Cal Products, Inc. To order replace parts or schedule service please call our office at (800) 851-4192 or use our website… www.imperialhoods.com. PARTS: When ordering Parts we need the following information: Model Number (not serial number) found on UL label inside hood.
Page 7
LED BULB—PAR 20 FLOOD LAMP—DIMMABLE Warning: Do not use any bulbs that are not instructed by manufacturer. Your Imperial Warranty: MUST show proof of original purchase date is needed to obtain service under warranty. Deluxe Units: Seven Year Limited Warranty, Parts and Labor in the Continental USA.
Page 8
SAFETY INSTRUCTIONS Read and Save These Instructions Warning: To reduce the risk of fire, electrical shock or injury to persons, observe the following: Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock Service Disconnecting Means to prevent power from being switched on accidentally.
Page 10
Sélectionnez 10—1900-10 Slim Lin—N1900 Instructions d'installation & Informations sur la garantie 425 Rue Apollo Brea CA 92821 www.imperialhoods.com (800) 851-4192 PROPRIÉTÉ DU PROPRIÉTAIRE DE LA MAISON, NE PAS JETER !
Page 11
Impériale Cal Products, Inc. Lire avant de commencer l'Installation ! Inspecter avant d'installer votre hotte de cuisinière ! Les défauts cosmétiques doivent nous être signalés avant l'installation. Une fois cette hotte est installée, ICP n'acceptera aucune responsabilité pour toute les imperfections cosmétiques, rayures ou bosses dans la canopée. Enregistrer tous les emballages d'origine si vous voulez retourner pour n'importe quelle raison ! TOUT D'ABORD :...
Page 12
Détail d'Installation Liners alimenté : MODELS: MODELS: MODELS: N1900SD4 N1900BP1 N1900BP N1900SD4 N1900PS N1900SD2 Armoire : N'oubliez pas que la base de l'armoire est de niveau, côté à l'autre et d'avant en arrière. BP, SD2 & SD4: couper un trou de 8 « x 8 » en bas de l'armoire, 3/4 "de la paroi arrière et sur la ligne médiane.BP1 : Découper un trou de 8 «...
Page 13
Détail d'Installation Liners alimenté : MODELS: MODELS: MODELS: 1900SD4-10 1900PS-10 1900PSB-10 (Baffle Filters) Armoire : N'oubliez pas que la base de l'armoire est de niveau, côté à l'autre et d'avant en arrière. PS: Découper un trou de 8 « x 8 » en bas de l'armoire, 3/4 "de la paroi arrière et sur la ligne médiane.
Page 14
Instructions d'installation pour l'application de montage mural. Par fond de hotte, mesurer 10 "vers le haut et tracez une ligne. Relever le support d'installation forme « U » et la ligne au bas de la fixation avec le support d'installation de ligne (Centre support gauche à droite) à l'aide de #10 x 2-1/2 "bois de vis, si vous avez des bois à...
Page 15
Impériale Cal Products, Inc. Pour commander des pièces ou annexe service, veuillez appeler notre bureau au (800) 851-4192 ou utiliser notre site Web... www.imperialhoods.com. PIÈCES : Lorsque vous commandez des pièces nous avons besoin des informations suivantes : Numéro de modèle (pas les numéro de série) sur l'étiquette d'UL à l'intérieur de la hotte. Dimensions exactes (dans le cas des filtres) Vous pouvez trouver le numéro de modèle à...
Page 16
Entretien & garantie Information Ce produit est le plus simple des exigences en matière de nettoyage. Pour supprimer les filtres des baffles, enlever le panneau Centre en tirant le panneau vers l'avant de la hotte, soulever pour la supprimer. Déplacer les filtres au centre du capot, déflecteur de tirer vers l'avant de la hotte et sortez.
Page 17
CONSIGNES DE SÉCURITÉ Lire et conserver ces Instructions AVERTISSEMENT : Pour réduire le risque d'incendie, de chocs électriques ou de blessures, respectez les points suivants : Utilisez cet appareil que de la façon prévue par le fabricant. Si vous avez des ques- tions, contactez le fabricant.
Page 19
Mail warranty card to: Imperial Cal Products ATTN: Warranty Department 425 Apollo St. Brea, CA 92821 Or visit our website to complete warranty registration: www.imperialhoods.com...
Need help?
Do you have a question about the Select 10 1900-10 and is the answer not in the manual?
Questions and answers