Sealey TRP200 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instructions gloves
1. SAFETY
WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
‰
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator. A risk assessment should be performed prior to use.
WARNING! Ensure all preliminary checks are carefully carried out before use and that all fixings are correctly and securely engaged.
‰
Immediately repair or replace damaged parts (use authorised service agent). Ensure use of genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
WARNING! Use jack on level and solid ground, preferably smooth concrete. Ensure the floor over which the loaded jack will be
‰
transported is swept clean.
WARNING! Ensure that the loaded item is correctly supported, well balanced and secured in place prior to final removal from vehicle
‰
and before any movement of the loaded jack within the workshop.
DO NOT make any modifications to the unit supplied.
8
DANGER! DO NOT use on tarmacadam, or any other soft surface as jack may sink or topple. Serious injury may result if ignored.
▲
▲ DANGER! If the load tips or leans, stop what your are doing. MOVE QUICKLY TO A SAFE DISTANCE. DO NOT TRY TO HOLD
OR STEADY JACK.
The unit is intended for use only with Sealey transmission jacks.(TR / ETJ and TRQ models in our ranges).
9
Ensure that load adaptor is correctly attached to the jack and that the grub-screw is fitted before use.
9
2. INTRODUCTION
Attaches to the existing pronged saddle, fitted to our TR, ETJ and TRQ model transmission jacks. This plate will assist in working on
fuel tanks, sub frames, transmissions and many other tasks. The chemical resistant rubber pad protects the point of contact. Supplied
with four eyelets to fasten down the load onto the plate. Powder Painted to create a durable and rust resistant finish.
3. SPECIFICATION
Model No.: ........................................................ TRP200
Capacity .............................................................. 200 kg
4. ASSEMBLY
4.1. Place the boss located on the underside of the Load Plate (fig.1) onto the Jack ram (fig.2). Fix in place ensuring the securing bolts
retain the plate centrally.
Underside of
load plate
© Jack Sealey Limited
TRANSMISSION JACK LIFTING PLATE 200KG
MODEL NO:
Wear safety
footwear
fig.1
Lifting
saddle
Original Language Version
TRP200
fig.2
Jack ram
TRP200 Issue 2 16/02/24