Advertisement
Quick Links
Advertisement
Related Manuals for MULTILANE ML4064-MCB-112
Summary of Contents for MULTILANE ML4064-MCB-112
- Page 1 ML4064-MCB-112 Technical Reference MSA Compliant OSFP MCB multilaneinc.com...
- Page 2 Table of Contents Introduction ........................3 Key Features ........................3 Ordering options ......................3 ML4064-MCB-112 Hardware ..................4 4.1 Power-Up ..........................4 4.2 Operating Conditions ......................4 4.3 LED Indicators ........................4 4.4 Low Speed Signals ......................... 5 4.4.1 External I2C ........................5 4.4.2 External HW Control ......................
- Page 3 Introduction The ML4064-MCB-112 is designed to provide an efficient and easy method of programming and testing 800G OSFP transceivers and active optical cables. It includes a complete user-friendly GUI supporting all features defined by OSFP MSA and simplifying configuration processes to enable intuitive memory map programming and testing.
- Page 4 OR banana plug U8 Table 1: Voltage Operating Conditions 4.3 LED Indicators The ML4064-MCB-112 includes on-board LEDs, for quick debugging and monitoring purposes. LEDs are summarized below: • LED D11 indicates whether a USB cable is plugged or not. • LEDs D13 and D12, colored green and red, respectively, are used for diagnostic purposes: ✓...
- Page 5 4.4 Low Speed Signals 4.4.1 External I2C The I2C bus can be accessed externally using U156 pins. In this case a jumper should be placed on pin header P16 (HW_I2C) shown in the image below. Figure 1: External I2C 4.4.2 External HW Control Also Low Speed Signals are controllable using an external source, this can be done through J4 pin header.
- Page 6 5.1 USB Driver In order to be able to communicate with the board, user need to install the USB driver of the ML4064-MCB-112. This is available on the website under the following link (USB Driver icon): https://www.multilaneinc.com/product.php?pn=ML4064-MCB-112 Below is a brief guide on how to install the USB Driver:...
- Page 7 Bootloader Accessing in bootloader mode allows the user to reprogram the microcontroller, this is done as described below: 1. Connect a jumper on (J1) situated close to the microcontroller. 2. Connect a USB cable between the PC and Board. 3. Power up the board with a +3.3V supply. 4.
- Page 8 Revision History Date Revision Description 8/14/2024 ▪ Initial Version 8/20/2024 ▪ Updated Section 2 10/28/2024 ▪ Added section 3 North America Worldwide Asia 48521 Warm Springs Blvd. Suite 310 Houmal Technology Park 14F-5/ Rm.5, 14F., No 295 Fremont, CA 94539 Askarieh Main Road Sec.2, Guangfu Rd.
Need help?
Do you have a question about the ML4064-MCB-112 and is the answer not in the manual?
Questions and answers