Table of Contents
Advertisement
MCS 4000 mission control software
Note:
Note:
Auto Setup Assistant will start analyzing the RF environment (Environment Scan).
You can monitor this process on the screen by selecting "Watch environment scan".
This will bring up the following window:
Environment Scan detects potentially interfering transmitters or strong intermodulating
transmitters above/below the threshold settings you selected in "Config..." - "Configure
Auto Setup". Since the system will scan the entire 30 MHz-wide frequency band, it is
imperative that you switch on all other transmitters near your WMS 400 system to get a
meaningful analysis.
If your system uses several bands, click on the upper left-hand tab in the "Environment
Scan" window to select the desired band.
Once the RF environment has been scanned, the receivers connected to the system will
be automatically set to new interference and intermodulation-free frequencies and unused
receivers will be switched off.
The following window appears as the programming starts:
9
Advertisement
Table of Contents
