Table of Contents
Advertisement
MCS 4000 mission control software
• Changing the Window
Note:
• Stopping the Recording
• Snapshot
• Deleting Monitoring Data
Note:
3.8 Environment Scan
Important!
1. Move the cursor to the separation line between the left-hand and right-hand sections of
Size
the window to bring up a double arrow.
2. Press and hold the mouse key and move the separation line to set the desired ratio
between the two sections of the window.
Your setting will be saved as a default setting.
Red lines mark receivers that have been switched off.
Select ("View" - "Open Rehearsal Check" -) "Stop History Recording...".
The recording of RF signal levels will stop.
Click on the camera symbol button.
A snapshot of the signal strengths at the receiving antennas will be saved in a specified
folder.
Select ("View" - "Open Rehearsal Check" -) "Clear History Recording...".
All monitoring data for all channels will be deleted from RAM and from the hard disk.
"Clear History" does not stop the recording.
Environment Scan allows you to identify potentially interfering transmitters or strong inter-
modulating transmitters (above/below the thresholds you set in "Configure Auto Setup") for
individual microphone channels. Since the system will scan the entire 30 MHz-wide frequen-
cy band, it is imperative that you switch on all other transmitters near your WMS 400 system
to get a meaningful analysis.
•
You cannot use the receivers selected for Environment Scan for signal reception
during the scan.
•
We recommend saving the current system settings selecting "File" - "Save System
to Disk..." prior to starting Environment Scan to avoid losing receiver Presets and
frequencies due to a possible system or software crash.
1. Switch all WMS 400 transmitters OFF to make sure you will not "overlook" any interfer-
ence frequencies.
2. Switch all other transmitters near the system ON.
3. From the menu bar, select "Tools" - "Environment Scan...".
The screen will change as follows:
5. Click on "Start Scan" to start the scan or "Cancel" to quit the menu.
4. From the list next to "Select SR's for
scanning", select the receiver(s) whose
frequency (frequencies) you wish to
check.
Note:
If your system uses several bands, click
on the upper left-hand tab in the
"Environment Scan" window to select the
desired band.
12
Advertisement
Table of Contents
