AKG HUB 4000 Q User Instructions page 7

ON/OFF: Switches power to the unit on and off. The status LED next to the ON/OFF key will be lit green
to indicate power is on.
HiQnet LINK: This green LED will be lit constantly to indicate the unit is connected to a HiQnet™ net-
work.
HiQnet DATA: This green LED will flash to indicate the unit is receiving or sending data.
DATA TRANSFER TO AKG DEVICE 1-8: These blue LEDs indicate the status of data exchange between
the HUB 4000 Q and the AKG devices connected to it. Each LED is assigned to one of the rear panel
AKG NETWORK DEVICES 1 through 8 data ports.
Each LED indicates the following conditions:
LED flashing: Data is being exchanged between the assigned data port on the HUB 4000 Q and the
connected AKG device.
LED flashing slowly (approx. once every 3 seconds): There is a communication problem between the
assigned data port on the HUB 4000 Q and the connected AKG device (hard or software error, defec-
tive data cable, etc.).
LED is dark: No AKG device is connected to the assigned data port or the connection has been inter-
rupted.
HiQnet LINK: This RJ 45 socket accepts the connecting cable to the computer.
• The connecting cable is not supplied with the euiqpment. To connect the equipment directly to a com-
puter, use a crossover Ethernet cable. To connect the equipment to a standard Ethernet hub, use a
straight-through Ethernet cable.
AKG NETWORK DEVICES 1-8: RJ 11 sockets for connecting up to eight AKG devices (e.g., SR 4000
receivers.
12 V/500 mA: Locking DC input for connecting the included power supply (12 VDC, 500 mA).
Operate the equipment with the included power supply with an output voltage of 12 VDC,
500 mA only. Using adapters with an AC output and/or a different output voltage may
cause serious damage to the unit.
HUB 4000 Q
2 Description
2.4 Controls
2.4.1 Front Panel
Fig. 1: Front panel controls.
Refer to fig. 1.
2.4.2 Rear Panel
Fig. 2: HUB 4000 Q rear panel.
Refer to fig. 2.
Note:
Warning!
7