Gn 155 Set Installation Module; Gooseneck Extension; Hm 1000 Hanging Module - AKG DISCREET ACOUSTICS - SOFTWARE User Instructions

4 Installation and Connection
4.7 GN 155 SET In-
stallation Module
• To activate bass
cut, refer to Sec-
tion 4.3.2.
• For external
powering of LED
ring, refer to Sec-
tion 4.5.1.
Refer to fig. 7 (left).
4.7.1 Gooseneck
Extension
Refer to fig. 7 (right).
Fig. 7: GN 155 SET.
4.8 HM 1000
Hanging Mo o dule
36
5. If the phantom power on your mixing console is
switchable, switch the phantom power on. (Refer to
the instruction manual for your mixing console.)
6. External powering only: Connect the feeder cable for
the LED ring to a suitable voltage source.
7. Insert the jack plug on the gooseneck into the mini
jack on the mounting flange and screw the gooseneck
down.
1
4
3
2
4. Screw the Installation Module (1) onto the extension
stub (3) CW.
1. Prior to installing the HM 1000, straighten the cable
by carefully pulling it through your fingers. Make sure
not to buckle or twist the cable.
2. Fasten a hook to the ceiling, use an existing hook, or
stretch a line across the hall.
3. Pass the cable through the hook or over the line so
that it will hang at the desired height.
DISCREET ACOUSTICS modular
1. Screw the desired Cap-
sule Module onto the
Installation Module (1)
CW.
2. Screw the Installation
Module (1) onto the
supplied floor stand (2)
CW.
3. Connect the DPA phan-
tom power adapter to a
microphone input with
phantom power.
1. Screw the desired Cap-
sule Module onto the
Installation Module (1)
CW.
2. Screw the extension
stub (3) onto the sup-
plied floor stand (2) CW.
3. Slide the protective
sheath (4) over the ex-
tension stub (3).