IMT BigRef-IV-03 Instruction Sheet

Large-area Reference Cell
BigRef-IV-03 / BigRef-mV-03
Safety Instructions
The installation and assembly of electrical equipment must be carried out by electrically qualified persons.
The sensor may not be used with equipment whose direct or indirect purpose is to prevent human death or injury,
or whose operation poses a risk to humans, animals or property.
Warranty and Liability
The BigRef is designed for the measurement of artificial sun light. The warranty is for 1 year from the date of
the invoice for the intended use. IMT Technology does not accept any liability for possible losses or damage due to the
incorrect usage of the sensor. Liability for consequential damages is excluded.
Mounting Instructions
The mechanical assembly is carried out via the four mounting holes in the housing.
In order to operate the BigRef within the permissible operating temperature, the sensor must be cooled via the rear side
when using continuous light.
Electrical Connection
BigRef-IV-03:
Caution: The sense lines are
not protected against over-
current. Make sure that
these are only used as sense
for voltage measurement!
Caution: The current lines are not protected against over-
current. Make sure that the pink and white lines are always
connected to each other and the brown and gray lines are
always connected to each other.
Page 1/3
IN S T R U C T I O N S H E E T
www.imt-technology.com