Sunrise spas SSPA-1-SR3 Quick Reference Card

The Quick Reference Card provides a quick overview of your spa's main functions and the operations accessible with
your digital control pad. Note: Functionality depends on system configuration (system can also be equipped with a TSC-19).
Starting the pump:
Press Jets to turn pump on at low speed. Press a second time
to turn pump to high speed. A third time turns pump off. With
blower option, pressing a second time keeps pump on at low
speed and turns blower on. A third time turns pump to high
speed and keeps blower on, a fourth time turns blower off and
a fifth time turns pump off.
A built-in timer turns pump (and/or blower) off after 20 minutes,
unless it has been manually deactivated.
The "Pump" indicator lights up when pump
(and/or blower) is on.
Turning the light on:
Press Light to turn light on. Pressing a second time turns light off.
A built-in timer automatically turns light off after 2 hours, unless it
has been manually deactivated.
The "Light" indicator is displayed
when light is on.
CoolRays option: refer to CoolRays user's manual.
Automatic water heater start:
When water temperature is 1˚F (0.5˚C) lower than the Set Point,
the heater will automatically turn on until water temperature
reaches Set Point plus 1˚F (0.5˚C).
The "Heater" indicator lights up when the heater is on.
It flashes when there is a request for more heat but
the heater has not yet started.
Setting water temperature:
Use Heat or Cool arrow key to regulate water temperature.
The temperature setting will be displayed for 5 seconds to
confirm your new selection.
The "Set Point" indicator displays the desired temperature,
NOT the current water temperature!
Water temperature can be adjusted by 1˚ increments from
59 to 104˚F (15 to 40˚C).
SSPA-1-SR3
"Pump" indicator
"Light" indicator
"Heater" indicator
"Set Point" indicator
QuickReferenceCard