Raptor DL-Lite X11R6.1 for AIX Installation Manual
4.3.1.1
STARSMODE Variable
The bit-depth of the Raptor DL-Lite card can be set using the
STARSMODE environment variable. This variable should be set
before starting up the X server.
For example, set the bit-depth of the Raptor DL-Lite card to 8+24
prompt%
setenv STARSMODE +8+24
To set the bit-depth of the Raptor DL-Lite card to mox16
prompt%
setenv STARSMODE +mox16
Other bit-depths can be selected in a similar manner.
NOTE: In the case when both methods to set bit-depth are used,
the STARSMODE variable takes precedence over the settings in the
TSIScreenConfig file.
4.3.1.2
Config File
The depth of the Raptor DL-Lite card can be set using the
/usr/X11R6.1/etc/TSIScreenConfig file. Each row in the
file corresponds to a specific Raptor DL-Lite card that is identified
by its device name. The fields in each row are separated by
spaces. In the sample config file shown below the bit-depth of the
Raptor DL-Lite (rapdlt0) card is set to 8+24. The cached pixmap
field is used for debugging purposes only and should always be set
to 1. The other fields are discussed in 4.3.2.
# device
Depth
rapdlt0
8+24
The default visual in 8+24-bit mode is PseudoColor. In order to set
the default visual in the 8+24-bit mode to TrueColor, the X Server
should be started with command line option cc set to 4. The
example below shows how to set the default visual to TrueColor for
the card rapdlt0.
Resolution Sync Cached Resfile
DEFAULT
1
4-4
pixmap
1
trzresinfo
Need help?
Do you have a question about the RAPTOR DL-LITE - X11R6.1 FOR AIX INSTALLATION-REFERENCE and is the answer not in the manual?