Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Labtron LDVP-A10
Summary of Contents for Labtron LDVP-A10
- Page 1 Diaphragm Diaphragm Vacuum Pump Vacuum Pump LDVP-A10 LDVP-A10 www.labtron.com info@labtron.com...
- Page 2 Diaphragm Vacuum Pump LDVP-A10 Index Sr.no Title Page no Safety Measures Introduction Features Specifications Applications Installation Maintenance Troubleshooting...
- Page 3 Diaphragm Vacuum Pump LDVP-A10 1. Safety Measures • Read these instructions carefully before you attempt to use this product. • Read this information carefully before proceeding The following is an explanation of the two different types of hazards: Protective Conductor Terminal Caution, hot surface This product must only be used to pump/evacuate air.
- Page 4 Diaphragm Vacuum Pump LDVP-A10 2. Introduction Diaphragm Vacuum Pump LDVP-A10 with nitrile (NBR) pump material is equipped with an automatic cooling exhaust system to ensure continuous 24-hour operation & deliver contamination-free air, gases, or vapors. Its high-quality classical axle tree design enables steady running with low noise and high operating efficiency.
- Page 5 Diaphragm Vacuum Pump LDVP-A10 4. Specifications 12 L/min Model No. LDVP-A10 ≥ 0.075 MPa Pumping Speed 250 bar Ultimate Pressure Nitrile Rubber (NBR) Vacuum 75 W Material of diaphragm pump φ 6 mm Power φ 6 mm Inlet < 55 °C Outlet 7 to 40°C...
- Page 6 Diaphragm Vacuum Pump LDVP-A10 6. Installation • Disconnect the electrical power supply before installing and/or servicing. Failure to do so could result in electrical shock, personal injury, or death. • To avoid the risk of electrocution do not use this product in an area where it could meet water or other liquids.
- Page 7 Diaphragm Vacuum Pump LDVP-A10 7) Remove socket head cap screws and washers from the pump head and remove the head. 8) Tum the head over on the underside of the head, and remove the slotted valve screw, valve, and stainless valve. Discard old valves.
- Page 8 Diaphragm Vacuum Pump LDVP-A10 7. Maintenance • Switch the electricity supply OFF and isolate the product. • Vent all pressure/vacuum from the product. • Filter will become blocked quickly in dirty environments. • Regular inspection can prevent unnecessary damage and repairs.
- Page 9 Diaphragm Vacuum Pump LDVP-A10 8. Troubleshooting Always disconnect power before servicing. If the motor fails to start or it slows down under load, turn it off and unplug it. Make sure that the voltage at the power outlet agrees with the motor nameplate. Examine the plug, cord and switch for deterioration. If the pump gets overheated or is noisy, stop the pump immediately for repair.
Need help?
Do you have a question about the LDVP-A10 and is the answer not in the manual?
Questions and answers