Sherwood NewCastle R-772 Operating Instructions Manual page 23

R-772(A) 2007.8.16 5:21 PM 페이지 23
Erasing the programmed command from
one button
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select the
delecting mode ("DELETE").
• Then "BTTN" is displayed on the LCD screen for
several seconds.
2.
While "BTTN" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the one
command deleting mode (BTTN), then press the
ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, "BTTN" or "LEARN"(all
command deleting mode) is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step 1.
3.
While "SEL" is flickering, press the button for the
command you want to erase.
Example: When the button for the command to be
erased is PLAY button.
• "OK" is displayed and then "SEL" is flickering.
4.
While "SEL" is flickering, repeat the above step
3 to erase other commands.
Erasing all the commands programmed
under a device mode
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select the
deleting mode ("DELETE").
• Then "BTTN" is displayed on the LCD screen for
several seconds.
2.
While "BTTN" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the all
command deleting mode ("LEARN"), then press
the ENTER button.
• Then "SURE?" is displayed .
• If "SURE?" goes off, start again from the above
step 1.
3.
While "SURE?" is displayed, press the ENTER
button.
• Then all the commands programmed are erased.
4.
To erase all the commands programmed under
other device mode, repeat the above steps 1 to
3.
23