Recording A Motion Picture; Displaying A Motion Picture - Sharp AQUOS LC-26GA4U Operation Manual

Using memory card

Recording a motion picture

Use this setting to record images you are currently
watching.
Record with the settings made in "Rec. Mode" and
"Pre Record".
1
Press REC to start recording.
• CARD indicator lights up red.
• Recording information displays in the lower
right corner of the screen.
2
Press H to stop recording.
NOTE
The list of broadcasting type or input signal not available
for recording:
1 COMPONENT input
2 HDMI input
3 DVI-I input
4 Card picture
5 Copy guarded signal
6 V-chip blocked program
To display the remaining record time.
Press DISPLAY while not recording.
• Remaining record time displays in the lower right corner
of the screen.
NOTE
• Do not press POWER on the display while recording.
Recording cannot finish properly and may damage the
file.
• Recording stops if you press POWER on the remote
control while recording.
• When card has no capacity for recording, "Card is full"
displays and stops recording.
• You cannot change the channel or switch the input source
while recording.

Displaying a motion picture

1
Press CARD and the card mode screen
displays.
2
Press c/d to select "Video", and then press
ENTER.
3
Press a/b/c/d to select the file you want
to play, and then press ENTER.
• Video playback starts.
4
Press CARD again to display the operation
panel.
• See page 36 for the operation panel
information.
• When viewing a motion picture, by pressing
VIEW MODE the picture size changes.
Small – Medium – Large.
41