Initial Setup - Sharp AQUOS LC-26GA4U Operation Manual

Watching TV

Initial setup

When you turn on the TV for the first time, it will automatically memorize the broadcasting channels where you
live. Perform the following steps before you press TV POWER on the remote control unit.
1. Insert the batteries into the remote control unit. (See page 11.)
2. Connect the antenna cable to the TV. (See pages 15 to 17.)
3. Plug in the AC cord to the AC outlet. (See page 8.)
Language setting
Select from among 3 languages: English, French and
Spanish.
1
Press a/b to select the desired language
listed on the screen, and then press ENTER.
Language
Air/Cable
CH Search
Antenna setting
Make sure what kind of connection is made with your TV
when selecting "Air" or "Cable" for both ANT-A and B.
2
Press c/d to select "Air" or "Cable" for ANT-
A, then press a/b to move down.
Press c/d to select "Air" or "Cable" for ANT-
B.
Press ENTER to enter the setting.
• This operation makes the TV search for both
ANT-A and B.
• There are 3 kinds of CATV system, including
Standard, HRC and IRC. Select the one
matches to your TV. Select Auto when you do
not know which one to select.
Language
Air/Cable
CH Search
Language
Air/Cable
CH Search
English
Français
Español
Example
ANT-A Air
ANT-B Cable (Auto)
ANT-A Air
ANT-B Cable (Auto)
Channel search
Channel auto search makes the TV look for all channels
viewable in the set area.
3
Press c/d to select "Yes" for ANT-A, then
press a/b to move down.
Press c/d to select "Yes" for ANT-B, then
press a/b to move down to select "Search
Start" , and press ENTER.
Language
Air/Cable
CH Search
CH Search
ANT-A Air
CH Search
ANT-B Cable
ANT-A
NOTE
• Make sure what kind of connection is made with your TV
when selecting "Air" or "Cable" for both ANT-A and B.
• If no channel is found, make sure what kind of connection
is made with your TV and try EZ setup again (see page
24).
ANT-A Yes No
ANT-B Yes No
Search Start
Example
[ 25 ] Found [ 20 ]
[ 25 ] Found [ 20 ]
Air
2
Audio : MONO
19