1. Safety Instructions IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND KEEP FOR FUTURE REFERENCE Read this manual thoroughly before first use, even if you are familiar with this type of product. The safety precautions detailed will reduce the risk of fire, electric shock and injury when correctly adhered to.
To reduce the risk of fire, electric shock or injury, always follow basic safety precautions and accident prevention measures when using this appliance, including the following: 1.1 Electrical Safety • Voltage: Plug the appliance in a 220-240V, 50Hz, properly earthed power outlet, which must be in good working order.
1.3 Cleaning and Maintenance • Disconnect: Switch off and unplug the appliance from the mains socket before cleaning, maintenance or servicing. Failure to do so can result in electric shock, injury or death. Do not connect or disconnect the plug when your hands are wet. •...
2. Product Overview Thermostat control and interior light Glass shelves Channel drain Crisper drawer with glass cover Levelling feet Bottom door shelf (bottle rack) Upper door shelves NOTE: Due to continued product improvement, images and illustrations in this manual may vary slightly from the product purchased. All images in this manual are for reference purposes only.
3. Getting Started 3.1 Unpacking • Packaging materials: This product has been packaged to protect it against transportation damage. Remove all packaging materials from around and inside the appliance and keep the original packaging carton and materials in a safe place. It will help prevent any damage if the product needs to be transported in the future, and you can use it to store the appliance when it is not in use.
3. Getting Started (Continued) 3.3 Space Requirements Fig. 1 • Door opening: Place the unit so there is enough space for the door to open easily (Fig. 1). • Clearances: Ensure that air can circulate freely around the back of the cabinet, which is necessary to cool the compressor and condenser.
4. Operating Instructions 4.1 Temperature control • The control for regulating the temperature in the refrigerator compartment is located on the ceiling of the compartment, next to the interior light. The higher the number on the dial, the colder the temperature in the refrigerator compartment: 1 is the warmest setting, 5 is the coldest setting and 0 is off.
4. Operating Instructions (continued) 4.2 Fresh food storage The fridge compartment is suitable for short-term storage of all your fresh food. The temperature inside the compartment varies depending on the room temperature, the amount of food stored and the frequency of door opening. It is low enough to limit some bacterial growth, but it is not suitable for long-term storage of perishable foods.
4. Operating Instructions (continued) 4.4 Energy saving tips • Place the fridge in the coolest area of the room, away from heat-producing appliances and out of direct sunlight. • Let hot foods cool to room temperature before placing them into the fridge. Overloading the fridge forces the compressor to run longer.
5. FAQs & Troubleshooting Guide If you experience a problem with your fridge, check in the following table for solutions to help you solve the problem before you call customer service. Problem Possible cause The appliance does not • It is not plugged in. Ensure it is properly plugged operate.
Page 14
5. FAQs & Troubleshooting Guide (Continued) Moisture forms on the • Hot and humid weather increases the internal rate of frost build-up. This is normal. inside or outside walls of the fridge. • Open the door less often and make sure it is always properly closed.
6. Other Useful Information WARNING! To reduce the risk of electric shock or injury, always switch off the appliance and disconnect it from the power supply before cleaning or maintenance. 6.1 Cleaning the fridge • Turn the temperature control to the minimum position, unplug the fridge and remove the food, shelves and crisper drawer.
6. Other Useful Information (Continued) 6.4 Door reversal This appliance has the capability of opening the door from either the left or right side. If your set-up requires changing the opening direction, proceed as follow: IMPORTANT! You will need: • Make sure you have someone there to help you, do not try to do this on your own. •...
Page 17
Door reversal (continued) 3. Remove the cover and screws at the left side and fit them to the right side (Fig. 8). 4. Carefully lay down the rear of the cabinet on a soft pad. Remove the two levelling feet first, then unscrew the door hinge and the left foot base (Fig.
Page 18
Door reversal (continued) 6. Install the hinge at the left side and the foot base at the right side. Then screw the two levelling feet with their original parts (Fig. 12). 7. Unscrew the top hinge pin and mount it to the left hole (Fig. 13). Fig.
Page 19
6. Other Useful Information (Continued) 6.5 External handle installation For attachment of the handle or for repositioning to the opposite side, please follow the pictorial instructions below (Fig. 15). Fig. 15 living8co. AFTER SALES SUPPORT 0800 422 274...
Page 20
6. Other Useful Information (Cont.) 6.6 Water Tray Overflow For water overflow issues, please refer to the below table. Problem Possible cause Images • The fridge door has not been Excessive Fig. 16 closed for a period of time causing condensation hot air to enter the fridge and cause a large amount of condensation.
6. Other Useful Information (Continued) 6.7 Service and repair Do not attempt to alter or modify this appliance in any way. Do not attempt to repair or replace any part of the appliance unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician and only genuine spare parts must be used.
7. Warranty Read the manual. It will help you get the STOP best out of your product. BEFORE RETURNING Still have questions? TO STORE Call After Sales Support 0800 422 274 living8co. Warranty We pride ourselves on producing a range of quality products that are both packed with features and completely reliable.
Need help?
Do you have a question about the TWL331 and is the answer not in the manual?
Questions and answers