HSS Hire 56764 Operating & Safety Manual

Model 1...
Operating & Safety Guide 809
Turn the thermostat knob clockwise to its maximum.
Model 2...
Turn the thermostat knob anti-clockwise to its
maximum.
Whichever Model You Are Using...
The compressor is fitted with a timed delay switch
and will not run until 4 minutes have passed.
Once running, allow a minimum of 10 minutes for it to
begin cooling.
Once the desired room temperature has been
reached gradually turn the thermostat knob
anticlockwise (model 1) or clockwise (model 2) until the
machine clicks. The unit will now only emit chilled air
when the room temperature rises.
Finally adjust the fins at the front of the machine to
direct the airflow as required.
EQUIPMENT CARE
Never push the equipment beyond its design
limits. If it will not do what you want with reasonable
ease and speed, assume you have the wrong size or
quantity of air conditioners for the job. Contact your local
HSS Hire Shop for advice.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
Only use the air conditioner for the purpose it was
designed for. Improper use may cause expensive
damage and could be dangerous.
Large Air
Regularly check the water drain tank (every 3-4
hours). There is a red warning lamp on the control
panel, which will illuminate when the tank is full. The
unit will also turn itself off.
Conditioner
Set all switches to OFF and leave the unit to stand
for a minimum of 5 minutes before emptying the
tank.
Never remove the tank when the unit is operating
and always ensure that the tank is replaced
A heavy duty air conditioner for use in
correctly before restarting.
large offices, conference rooms,
To empty (Model 1 only, release the catch on the
compartment cover) slide the tank out, empty then
restaurants and similar environments.
replace.
When not in use, store the equipment somewhere
...any comments?
clean, dry and safe from thieves. Protect this
If you have any suggestions to enable us to improve
equipment from frost and freezing conditions.
the information within this guide please fax your
FINISHING OFF
comments or write to the Product Manager at the
address below
Switch the unit OFF and unplug from its power
Fax: 020 8687 5001
supply, then empty the water tank.
Remove the exhaust hose, coil the power supply
cable and give the unit a final clean up ready for
©HSS Hire Service Group Plc 2003 No. 809/02
return, to your local HSS Hire Shop.
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
Code 56764