HSS Hire 56754 Operating & Safety Manual

With the indoor unit switched OFF and isolated
from its power supply, make all the connections
from the umbilical assembly.
All that remains is to plug the indoor unit into its
power supply and switch the supply ON.

BASIC TECHNIQUES

Control Panel
Green Cooling
Red Fault
ON / OFF
Lamp
Button
Amber
Red Fan
Fan Speed
Power ON
ON / OFF
Control
Lamp
Button
Check that the amber power supply ON lamp is
illuminated, then press the red fan ON/OFF button
to start the indoor unit' s fan. The outdoor units' fan
will start to operate ONLY when cooling is selected. Use
the fan speed control dial to select the indoor unit
fan speed.
If chilled air is required, press the green 'cooling'
ON/OFF button and turn the thermostat control
clockwise to maximum.
The unit is fitted with a time delay device that will
prevent the compressor from
approximately 4 minutes
The unit will now be running, allow a minimum of
10 minutes for it to begin cooling.
Once the desired room temperature has been
reached, gradually turn the thermostat control
anti-clockwise until you hear a 'click'. The unit will now
only emit chilled air when the room temperature rises.
Finally, adjust the outlet grill fins at the front of
the machine to direct the airflow as required.
If the red fault lamp illuminates, switch the unit
OFF and isolate it from its power supply, then
contact your local HSS Hire Shop for advice.

EQUIPMENT CARE

Never use the Split Unit Air Conditioner except for
its intended purpose, If it will not do what you want,
assume you have the wrong equipment for the job.
Contact your local HSS Hire Shop for advice.
Only use the Split Unit Air Conditioner for the
purpose it was designed for. Improper use may cause
expensive damage and could be dangerous.
Keep the equipment clean. You will find it less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
Switch the unit OFF and unplug from its power
supply,
Remove all umbilical assembly connections from
Thermostat
both the indoor unit and the outdoor unit.
Control
Finally, neatly coil the umbilical assembly and the
indoor unit' s power supply cable, ready for return
to your local HSS Hire Shop.
starting for
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
©HSS Hire Service Group Plc 2000 No. 950/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk

FINISHING OFF

Contact your local
0845 728 2828
...any comments?
address below
Fax: 020 8687 5001
Operating & Safety Guide 950
Hire Shops
Split Unit Air
Conditioner
A mobile unit for halls, large offices
and similarly sized areas.
Code 56754/56755