Samsung SCC-B5393 User Manual page 14

To install the camera side on a pipe
1. Pull the power and video cables through
2. Attach the removed side cover to the
14
AB68-00649D(02)Eng.indd
the pipe connection hole on the camera
side
1) Remove the side cover from the Case
using a coin or minus (-) driver. (Rotate
counterclockwise.)
2) Push the power and video cables
stretched outside of the bottom hole
into the Case. And pull them out from
the side cover of the Case.
bottom hole and rotate it clockwise using
a coin or minus (-) driver. (Be sure to
insert the O-ring (P22 T2.4) into the hole
before assembly. The ring is necessary
for waterproofing.)
14
3. After pulling the power and video cables
through the connection pipe, screw the
male thread pipe into the female pipe
thread in your camera tightly to fix the
Main body. (In this case, be sure to tape
with Teflon tape before assembly for
waterproofing. Be careful for the wiring
cable not to be stuck in the connection
area.)
4. Adjust the lens direction. For more
information, see page 17, "Adjusting the
camera direction."
5. Attach the Dome cover. For more
information, see step 3 in "To install your
camera bottom on a pipe" on page 13.
2007-05-14 ｿﾀﾈﾄ 7:42:12