Advertisement
Quick Links
Skan Boost 10000
Jump Starter
JM-No. 609 03 94
Scope of supply:
JMP Skan Boost 10000, mains power cable
Thank you for choosing the JMP Skan Boost 10000 jump starter. The JMP Skan Boost 10000 jump starter is
suitable for jump-starting cars, vans, small lorries, boats, mobile homes, motorbikes, scooters, quad bikes, etc.
The jump starter must be charged for at least 8 hours immediately after purchase and after every use. If the jump
starter is not used, it must be charged for 8 hours at least once every 3 months in order to preserve the efficiency
of the battery. Under no circumstances must the jump starter be left uncharged for an extended period of time, as
this can deplete the efficiency of the battery considerably and affect the proper functioning of the device.
Technical data:
12 V / 2.000 A continuous, 10.000 A peak current
24 V / 1.000 A continuous, 5.000 A peak current
Dimensions: 350 x 240 x 140 mm, weight: 5 kg, connection cable: 0.5 m, slave battery: 9 V (6LR61) Charging
voltage: 14.5 V max., charger: 230 V / 50 Hz
Recommended for use between -10°C and +40°C
Suitable for:
• Standard lead acid
• Gel
• AGM
• EFB
• Lithium (LiFePO4)
Safety information:
These operating instruction must be kept in a safe place.
•
Warning! Risk of explosive gases.
Working in the vicinity of a lead acid battery is dangerous! The batteries generate explosive gases in nor-
mal operation. These instructions must therefore always be observed when using the device. In order to
reduce a battery's risk of explosion, these operating instructions and the instructions of the battery manuf-
acturer as well as those of the manufacturers of all machines to be used in the vicinity of the battery must
be observed.
Warning! Risk of electric shocks and accidents.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for JMP Skan Boost 10000
Summary of Contents for JMP Skan Boost 10000
- Page 1 JMP Skan Boost 10000, mains power cable Thank you for choosing the JMP Skan Boost 10000 jump starter. The JMP Skan Boost 10000 jump starter is suitable for jump-starting cars, vans, small lorries, boats, mobile homes, motorbikes, scooters, quad bikes, etc.
- Page 2 • These operating instructions must be read thoroughly before using the device. Failure to observe this requirement can result in injury or even have fatal consequences. • Keep out of reach of children. The device may only be used by children over the age of 8 and people with limited physical, sensory or mental capabilities or a lack of experience or relevant knowledge if such individuals are supervised or receive corresponding training in the safe use of the device and understand the associated risks.
-
Page 3: User Interface
• Only batteries with the voltages specified in the jump starter’s technical specification may be jump- started or charged. • Before jump-starting, the vehicle’s headlights and any equipment that may be switched on must be switched off. • Caution. The two battery clamps (positive red and negative black) must not come into contact! •... - Page 4 Jump-starting vehicles: Always wear safety goggles and keep your face away from the battery when connecting the charging cable. Check that the device is switched off. Check the voltage of the vehicle battery. Identify the terminal connected to the earth of the vehicle. Earth is usually connected to the negative terminal.
- Page 5 Caution. Do not reverse the polarity! Always connect the jumper cable with the red battery clamp (+) to the positive terminal on the battery and the jumper cable with the black battery clamp (-) to the earth of the vehicle. Caution: If the red LED reversed polarity illuminates, it means that the polarity is reversed.
-
Page 6: Error Messages
Error messages: Display Reason Err-1 Reversed polarity / short circuit / battery damage Err-2 Incorrect voltage Err-3 High temperature of battery in device Err-4 Lithium battery in device discharged Err-5 Err-6 Overloading in “Jump-starting” mode Err-7 Overloading in “Memory Saver” mode Err-8 Incorrect procedure for the “Override”...
Need help?
Do you have a question about the Skan Boost 10000 and is the answer not in the manual?
Questions and answers