SWS 55010 TC12 Quick Start Manual

55010 TC12 Traffic Utility Arrow
The following is a list of recommended practices for the installation and operation of your TC12.
FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS COULD RESULT IN
DAMAGE TO THE PRODUCT OR VEHICLE AND/OR SERIOUS INJURY AND/OR DEATH TO YOU AND
YOUR PASSENGERS
Proper installation of this product requires the installer to have a good understanding of automotive
electronics, systems and procedures. You may need to consult a professional for installation.
SWS Warning Systems Inc. recommends the use of waterproof butt splices and/or connectors for all
electrical connections. It is recommended that the use of good dielectric grease be used on all
connections where possible.
If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components
or other vital parts could be damaged by the drilling process. Also de-burr the holes and remove any
metal shards or remnants. Grommets are recommended for all wire holes.
Do not mount the TC12 close to antennae or radio equipment, as they may cause electromagnetic
interference. After installation of the TC12, it is necessary to test all electronic equipment
simultaneously to ensure that they operate free of interference from other components within the
vehicle.
Never power emergency warning equipment from the same circuit or share the same grounding
circuit with radio communication equipment.
Do not install this product or route any wires in the deployment area of your air bag or areas that
interfere with the operation of the vehicle.
deployment area and recommended mounting areas for warning lights and other equipment.
Do not attempt to activate or control the device with the vehicle in motion or in a hazardous driving
environment. The vehicle should be stopped and in park before control of the TC12 is attempted.
Do not stare directly into these lights. Momentary blindness and/or eye damage could result.
Use only soap and water to clean the product. Use of other chemicals could result in degradation and
discolouration of the lens/dome.
Do not use a pressure washer to clean this product.
Inspect and operate this product regularly to confirm its proper operation and mounting condition.
It is recommended that these instructions be stored in a safe place and referred to when performing
maintenance and/or reinstallation of this product.
SWS Warning Systems Inc. and its subsidiaries are not responsible for any damages due to
improperly mounted or improperly wired lighting equipment.
_____________________________________________________________________________________
SWS 7695 Blackburn Parkway, Niagara Falls, ON Canada
Tel: 1-877-357-0222 | Fax: 905-357-9122 | sales@swssafety.com
or the air bag
300186 Rev. 2
Page 1 of 2