KI All Terrain ANSW45 Assembly Instructions

ANSW45/, ABSW57/,
ANSW63/, ANSW69/
Note: Position longer legs
toward front of table edge.
ATSL3658/
Note: Position longer legs
toward front of table edge.
ANRC3042/,
ANRC3048/, ANRC3060/
Step 4
Figure 1
Fixed-Height Nesting Tables and Pin-Height Adjustable Monitor Stand
ANRC2448/, ANRC2460/, ANRC2742/,
ANRC2748/, ANRC2760/
ANEL2745/,
ANEL3658/
ATSL2745/
Step 3
Assembly Instructions
All Terrain Mobile Furniture
®
October 2009
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
TOOLS REQUIRED
• #2 Phillips screwdriver
• / " open end wrench
3
4
(for tables and casters)
HARDWARE INCLUDED
• (12) / -20 x / " Phillips pan head
1 3
4 4
screw with nylon patch
• 4 total of one of the following:
locking casters (46.5147)
non-locking casters (46.5146)
glides (10.3000BLWH)
1. To avoid scratching the tabletop,
place it face down on a soft
protective material. Refer to the
top and base packaging labels to
identify the table model number.
Identify applicable table
illustration.
Note: It may ease assembly
of the nesting base to raise the
tabletop 6" or more off the fl oor.
Note: Fronts of tables are at the
top of the illustration.
2. Unpackage appropriate table base
and refer to illustrations to the left
for proper base/leg
orientation. Set the base in place
on the underside of the work
surface aligning attachment holes
with threaded inserts in the work
surface tops as shown (Figure 1).
3. Using two attachment screws,
secure the hinge side of the bases
on each side (Figure 1).
4. Open the hinged base mecha-
nisms and complete base
attachment using the remaining 8
screws (four per side) (Figure 1).