Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Altrad Lescha CPHL Series
Summary of Contents for Altrad Lescha CPHL Series
- Page 1 Original instructions...
- Page 2 Duly authorised person for the complilation of technical documents: instruction can lead to injuries or cause damage to property. Altrad Lescha GmbH – Josef-Drexler-Straße 8 - 89331 Burgau - Germany Important information on proper handling. Not observing this instruction can lead to faults.
-
Page 3: Normal Intended Use
In addition, in spite of all the precautionary measures taken, non-obvious Assembly, operation and servicing. Here you are explained residual risks can still exist. exactly what to do. Safe working Normal intended use Woodworking machines can be dangerous if not used properly. If This construction circular saw is exclusively designed for lengthwise and electrical tools are used, the fundamental safety precautions must be cross cutting of solid wood and plate material such as chipboard, wood... -
Page 4: Electrical Safety
The supplied splitting wedge must be used. Fig. 15 shows how the − Damaged guards and parts must be properly repaired or exchanged splitting wedge is inserted and reset. by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Replace the bench insert if the sawing gap is worn. -
Page 5: Switching Off
• • Check the following prior to use: -1.5 mm² for a cable length of up to 25 m. • Defective connecting lines (cracks, cuts, etc.). -2.5 mm² for a cable length exceeding 25 m. Never use defective lines! • 2,5 mm²... -
Page 6: Working With The Saw
Only one LED is on: 1) One phase has failed: Have the supply line checked immediately by an electrician. 2) LED module (361642) defective: Have it replaced immediately by an electrician. Working with the saw You may not start to operate the machine until you have read these operating instructions, observed all the instructions given and installed the machine as described! Before making adjustments to the saw settings (e.g. -
Page 7: Using The Pushstick
Cutting wedges using the wedge cutting stop Connecting a chip extractor Chip ejector slot closed (operation with chip extractor) Using the pushstick A chip extractor can be connected to the saw to extract the chips. (Diameter of extractor nozzle: 100 mm.) Close the sealing blade on the chip ejector slot and secure it using the machine knob. -
Page 8: Blade Guard Adjustments
Take care that the saw blade remain free of rust and resin. 5. Now, the front saw blade flange (26) and the saw blade (25) can be Resin residues must be removed from the table board. removed. Resin residues can be removed with a commercial maintenance Clean the saw blade flanges. -
Page 9: Possible Faults
Transport Storage Before each transport: − Switch off device Pull out power plug − Wait unitl the saw comes to a stop. − Pull out power plug Store unused equipment in a dry, locked place out of the reach of children. −... -
Page 10: Technical Data
Technical data CPHL 400 CPHL 450 CPHL 500 Mains voltage 50 Hz WS-Motor Mains frequency 230 V~ Motor rating P 3,0 kW - S 6 – 40 % Motor output P 2,2 kW -S 6 – 40 % No-load speed 2698 min –1 DS-Motor... - Page 11 Description of device / spare parts...
- Page 12 Altrad Lescha GmbH Josef-Drexler-Straße 8 89331Burgau Germany Internet: www.lescha.de 361787-01...
Need help?
Do you have a question about the CPHL Series and is the answer not in the manual?
Questions and answers